NGP 143 Series Mortised Astragal Seals Instructions
- September 3, 2024
- NGP
Table of Contents
143 Series Mortised Astragal Seals
Product Information
Specifications:
- Manufacturer: National Guard Products Inc.
- Models: 143P, 143N, 143S Mortised Astragal Seals
- Mortise Size: 1/4″ to 5/8″
- Coil Spring: Included
Product Usage Instructions
Installation Instructions:
-
Cut astragal to the required length.
-
Prepare the door by mortising a 7/16″ wide x 5/8″ deep
groove. -
Insert screws into the pre-drilled holes in the astragal and
then slide springs over the tips of the screws. -
Install the astragal into the mortised portion of the
door. -
Turn every screw approximately halfway in.
-
Tighten each screw to the necessary depth to close the gap
between the doors. -
Slide gasket material into the metal retainer.
-
Adjust the seal so it does not impede the proper closing and
latching of the doors.
FAQ
Q: Can I use this astragal seal on any type of door?
A: The astragal seal is designed to be used on doors with a
mortised portion. Ensure that your door meets the specified mortise
size requirements for proper installation.
Q: Do I need any special tools for installing the astragal
seal?
A: Basic tools like a saw for cutting, a screwdriver for
inserting screws, and a measuring tool for ensuring correct mortise
dimensions are recommended for installation.
National Guard Products Inc.
1-800-647-7874
143P, 143N, 143S Mortised
Astragal Seals
1/4″ 5/8″
min. mortise
7/16″ mortise
coil spring
Installation Instructions
1. Cut astragal to length. 2. Prepare the door by mortising 7/16″ wide x 5/8″
deep. 3. Insert screws into holes in astragal and then slide springs over tips
of screws. 4. Install astragal into mortised portion of door. 5. Turn every
screw approximately halfway in. 6. Then tighten each screw the necessary depth
required to close the gap between the doors. 7. Slide gasket material into
metal retainer. 8. Adjust so seal does not impede proper closing and latching
of the doors.
Instrucciones de Instalación
1. Corte el astrágalo a la medida. 2. Prepare la puerta haciendo una muesca
de 7/16″ de ancho por 5/8″ de profundidad. 3. Inserte los tornillos en los
orificios del astrágalo y luego deslice los resortes sobre las puntas de los
tornillos. 4. Instale el astrágalo en la muesca hecha en la puerta. 5.
Enrosque los tornillos aproximadamente hasta la mitad. 6. Ahora enrosque todos
los tornillos lo suficiente para cerrar el espacio entre las puertas. 7.
Deslice el empaque dentro del retenedor metálico. 8. Ajuste para que el sello
no impida cerrar y correr debidamente el pasador de las puertas.
8/13
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>