MOTHERWELL MWL-421 421B Solo Luggage Rack Installation Guide
- September 2, 2024
- MOTHERWELL
Table of Contents
MOTHERWELL MWL-421 421B Solo Luggage Rack
Product Usage Instructions
Use and Care:
Wash your accessories with mild soap and water. Do not use abrasive chemicals or cleaners. For chrome products, use non-abrasive automobile wax for polishing to maintain the appearance and increase longevity.
Installation Procedure:
- Remove the Pillion seat.
- Install foam on the back of the rack.
- Place the rack on the fender mounting points. Ensure the forward mount sits on top of the driver’s seat.
- Install the stock screw into the rear pick-up point on the rack (do not tighten).
- For the front mount, place the nylon washer on the rack with the stainless steel on top.
- Insert the supplied Phillips screw loosely.
- Tighten both screws down securely.
FAQs
Q: Can I carry more than 10 lbs on the rack?
A: No, it is recommended to never carry more than 10 lbs on the rack to avoid affecting handling.
Q: What tools are required for installation?
A: You will need a #2 Phillips Screw Driver Kit #5 for installation.
Specifications
- FITMENT: Touring Models 97-Up
- MAX CAPACITY: 10 lbs
- MATERIAL: 3/8” Solid steel
- TECHNICAL SPECS: Pillion Seat Replacement May require a mounting kit #MWL-2000-16.
PRODUCT INFORMATION
WELCOME :
These instructions describe the procedure for properly installing the Motherwell Products Solo Luggage Rack.
ATTENTION INSTALLER (if other than the owner):
Please forward this instruction sheet to the purchaser of this product as it contains valuable information necessary to the end user.
CAUTION:
Start screwing carefully to avoid cross-threading.
USE AND CARE:
Wash your accessories with the same care you use when washing your motorcycle. Use mild soap and water. DO NOT use abrasive chemicals or cleaners. We recommend the use of non-abrasive automobile wax to polish our chrome products. This will best maintain the appearance of the product and increase longevity.
WARNING:
Never carry more than 10 lbs. on the rack, and always secure cargo properly. Failure to do so can affect handling. Make sure neither cargo straps are loose nor come in contact with moving parts, i.e., wheels, brakes, etc.…
TOOLS REQUIRED
-
2 Phillips Screw Driver
- Kit #5
PARTS INCLUDED
- 1 Phillips ¾” Pan Head Screw
- 5 Nylon Washers
- 1 Stainless Steel Washer
- 1 Foam Tab
MWL Part #:
- FAS-009,
- 0FAS-003,
- FAS-005
- FOAM-AFT
MOUNTING PROCEDURE
- Remove the Pillion seat.
- Install foam on the back of the rack.
- Place rack on fender mounting points. (The forward mount sits on top of the driver’s seat)
- Install the stock screw into rear pick-up point on the rack. (DO NOT TIGHTEN)
- For the front mount, place the nylon washer on the rack with the stainless steel on top.
- From there insert the supplied Phillips screw loosely.
- Proceed to tighten both screws down.
CONTACT INFORMATION
- Motherwell Products USA, Inc
- 7074 Portal Way #140
- Ferndale, WA 98248
- Toll Free 877-703-7118
- www.motherwellproducts.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>