MOTHERWELL MWL-530-09, 530-09B Solo Luggage Rack Installation Guide

: September 2, 2024
: MOTHERWELL

Table of Contents

MOTHERWELL MWL-530-09, 530-09B Solo Luggage Rack
Product Usage Instructions
FAQs
SPECIFICATION
PRODUCT INFORMATION
TOOLS REQUIRED
PARTS INCLUDED
MOUNTING PROCEDURE:
CONTACT INFORMATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)
2 Phillips Screw Driver

MOTHERWELL MWL-530-09, 530-09B Solo Luggage Rack

MOTHERWELL-MWL-530-09,-530-09B-Solo-Luggage-Rack-
PRODUCT

Product Usage Instructions

Installation

Remove the Pillion seat.
Install foam tabs on the back and front of the rack.
Place the rack on the fender mounting points. (The forward mount sits on top of the driver’s seat)
Install the stock screw into the rear pick-up point on the rack but do not tighten it.
For the front mount, place the nylon washer on the rack with the stainless steel washer on top.
Loosely insert the supplied Phillips screw into the front mount.
Tighten both screws down securely.

Use and Care:

Wash your accessories with mild soap and water, similar to how you wash your motorcycle. Avoid using abrasive chemicals or cleaners on the rack.

Warning:

Never exceed a load of 10 lbs on the rack, and always ensure cargo is properly secured to avoid affecting handling. Check that cargo straps are not loose and do not contact moving parts like wheels or brakes.

FAQs

Q: Can this luggage rack fit other motorcycle models?

A: The luggage rack is specifically designed to fit Dyna Models from 2006 onwards and Street Bob Models from 2009 to 2017. It may not fit other models without proper modification.

Q: What should I do if I encounter cross-threading while installing?

A: If you encounter cross-threading while starting a screw, stop immediately. Back it out carefully and realign it before attempting to screw it in again to avoid damaging the threads.

SPECIFICATION

FITMENT: Fits Dyna Models 06-UP & Street Bob Models 09-2017
MAX CAPACITY: 10 lbs
MATERIAL: 3/8” Solid steel & ½” tubing outside
TECHNICAL SPECS: May require a fender/seat

PRODUCT INFORMATION

WELCOME:

These instructions describe the procedure for properly installing the Motherwell Products Solo Luggage Rack.

ATTENTION INSTALLER (if other than the owner):

Please forward this instruction sheet to the purchaser of this product as it contains valuable information necessary to the end user.

CAUTION:

Start screwing carefully to avoid cross-threading.

USE AND CARE:

Wash your accessories with the same care you use when washing your motorcycle. Use mild soap and water. DO NOT use abrasive chemicals or cleaners.

WARNING:

Never carry more than 10 lbs. on rack, and always secure cargo properly. Failure to do so can affect handling. Make sure neither cargo straps are loose and come in contact with moving parts, i.e., wheels, brakes, etc…

TOOLS REQUIRED

2 Phillips Screw Driver
Kit #3

PARTS INCLUDED

Luggage Rack
2 Phillips ¾” Pan Head Screw
2 ¼ Bond Seal S/S
1 Foam Tab

MWL Part #:

FAS-009, FAS-057, FOAM-AFT, FOAM-FWD

MOUNTING PROCEDURE:

Remove the Pillion seat.
Install foam tabs on the back and front of the rack.
Place rack on fender mounting points. (The forward mount sits on top of the driver’s seat)
Install the stock screw into the rear pick-up point on the rack. (DO NOT TIGHTEN)
For the front mount, place the nylon washer on the rack with the stainless steel washer on top.
From there insert the supplied Phillips screw loosely.
Proceed to tighten both screws down.