Motherwell Products MWL-166-1 Exclusive Luggage Rack for Short Detachable Sissy Bars Installation Guide
- August 31, 2024
- Motherwell Products
Table of Contents
Motherwell Products MWL-166-1 Exclusive Luggage Rack for Short Detachable
Sissy Bars Installation Guide
WELCOME: These instructions describe the procedure for properly installing the
Motherwell Products Solo Luggage Rack.
ATTENTION INSTALLER (if other than owner): Please forward this instruction
sheet to the purchaser of this product as it contains valuable information
necessary to the end user.
CAUTION: Start screw carefully to avoid cross threading.
USE AND CARE:
Wash your accessories with the same care you use when washing your motorcycle.
Use mild soap and water. DO NOT use abrasive chemicals or cleaners. We
recommend the use of non-abrasive automobile wax to polish our products. This
will best maintain the appearance of the product and increase longevity.
WARNING: Never carry more than 10 lbs. on rack, and always secure cargo
properly. Failure to do so can affect handling. Make sure neither cargo straps
are loose nor come in contact with moving parts, i.e., wheels, brakes, etc.…
TOOLS REQUIRED:
5/32” or 4 mm Allen Wrench Kit #24
PARTS INCLUDED: MWL Part #
Rack MWL-166-1
4 SS MG Flat Washers FAS-54
MOUNTING PROCEDURE:
-
Remove backrest from the bike if
-
Remove 4 bolts on the inside of the Sissybar side plates on Rack mounting
-
Slide luggage rack from inside bottom backrest to align with existing bolt
-
Reinsert the 4 bolts & the provided washers and tighten until just snug, check rack is square, and adjust as needed, then tighten bolts
Reinstall bar on bike
Great Rides Start With Motherwell
Motherwell Products USA, Inc 7074 Portal Way #140
Ferndale, WA 98248
Toll Free (877) 703-7118
www.motherwellproducts.com