MOTHERWELL MWL-151-18 Solo Luggage Rack

WELCOME
These instructions describe the procedure for properly installing the Motherwell Products Solo Luggage Rack.

ATTENTION INSTALLER (if other than the owner):

Please forward this instruction sheet to the purchaser of this product as it contains valuable information necessary to the end user.

Specifications

• Product Name: Motherwell Products Solo Luggage Rack
• Model: MWL-151-18
• Fitment: Softail Slim 2018-up
• Max Capacity: 10 lbs
• Technical Specs: May require a fender/seat mounting kit, part # MWL-2000-16

Installation Instructions

1. Remove the Pillion seat.
2. Install foam tabs on the back and front of the rack.
3. Place the rack on the fender mounting points. (The forward mount should sit on top of the driver’s seat).
4. Install the stock screw into the rear pick-up point on the rack without tightening it.
5. For the front mount, place the nylon washer on the rack with the stainless-steel washer on top.
6. Loosely insert the supplied Phillips screw and proceed to tighten both screws down.

Use and Care Instructions
Wash your accessories with mild soap and water, similar to how you wash your motorcycle. Avoid using abrasive chemicals or cleaners.

Caution
Start screws carefully to avoid cross-threading.

Warning
Never carry more than 10 lbs on the rack, and always secure cargo properly to avoid affecting handling. Ensure cargo straps are not loose and do not come in contact with moving parts.

Tools Required

• 2 Phillips Screw Driver

• Kit #15

PARTS INCLUDED: MWL Part #

• Luggage Rack MWL-151-18
• 2 Phillips ¾” Pan Head Screw FAS-009
• 2 ¼ Bond Seal S/S FAS-057
• 1 Foam Tab FOAM-AFT

MOUNTING PROCEDURE

1. Remove the Pillion seat.
2. Install foam tabs on the back and front of the rack.
3. Place rack on fender mounting points. (The forward mount sits on top of the driver’s seat)
4. Install the stock screw into the rear pick-up point on the rack. (DO NOT TIGHTEN)
5. For the front mount, place the nylon washer on the rack with the stainless-steel washer on top.
6. From there insert the supplied Phillips screw loosely.
7. Proceed to tighten both screws down.

FAQs

Q: Can I exceed the maximum capacity of 10 lbs on the luggage rack?
A: No, it is important not to exceed the specified maximum capacity to avoid any handling issues.

Q: How should I clean the luggage rack?
A: Clean the rack with mild soap and water. Avoid using abrasive chemicals or cleaners.

Motherwell Products USA, Inc
7074 Portal Way #140
Ferndale, WA 98248
Toll Free 877-703-7118
www.motherwellproducts.com

References

• Motherwell Products: Elevate Your Ride with Custom Big Bike Accessorie

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>