Motherwell Products MWL-151 Solo Luggage Rack Installation Guide

August 31, 2024
Motherwell Products

Motherwell Products MWL-151 Solo Luggage Rack Installation Guide

WELCOME: These instructions describe the procedure for properly installing the Motherwell Products Solo Luggage Rack.
ATTENTION INSTALLER (if other than owner): Please forward this instruction sheet to the purchaser of this product as it contains valuable information necessary to the end user.
CAUTION: Start screw carefully to avoid cross threading.

USE AND CARE:

Wash your accessories with the same care you use when washing your motorcycle. Use mild soap and water. DO NOT use abrasive chemicals, cleaners. We recommend the use of non-abrasive automobile wax to polish our chrome products. This will best maintain the appearance of the product and increase longevity.
WARNING: Never carry more than 10 lbs on rack, and always secure cargo properly. Failure to do so can affect handling. Make sure neither cargo straps are loose and come in contact with moving parts, i.e., wheels, brakes, etc

TOOLS REQUIRED: MOUNTING PROCEDURE:
#2 Phillips Screw Driver 1) Remove Pillion seat.
Kit #3 2) Install foam on back of the rack.
  3) Place rack on fender mounting points. (The forward
PARTS INCLUDED: MWL Part # mount sits on top of the driver’s seat)
Luggage Rack MWL-151 **4) Install the stock screw in to rear pick up

point on the
Kit #3| rack. (DO NOT TIGHTEN)
2 Phillips ¾” Pan Machine Screw FAS-009| 5) For the front mount, place the nylon washer on the
2 ¼ Bond Seal S/S FAS-057| rack with the stainless steel on top.
1 forward foam FOAM-FWD| 6) From there insert the supplied Phillips screw loosely.
1 aft foam FOAM-AFT| 7) Proceed to tighten both screws down.**

Read More About This Manual & Download PDF:

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals