VODALAND MONO 100 4 Inch Polymer Concrete Trench Drain Installation Guide

: August 28, 2024
: VODALAND

Table of Contents

VODALAND MONO 100 4 Inch Polymer Concrete Trench Drain
Product Specifications
Product Usage Instructions
FAQ
4” (100mm) MONO POLYMER CONCRETE TRENCH DRAIN
ABOUT COMPANY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

VODALAND MONO 100 4 Inch Polymer Concrete Trench Drain

Product Specifications

Product: MONO 100 (SPORT) SYSTEM – LOAD CLASS 250
Drain Type: 4 (100mm) MONO POLYMER CONCRETE TRENCH DRAIN
Materials: Polymer concrete
Compressive Strength: 14,000 PSI
Flexural Strength: 4,000 PSI
Tensile Strength: 1,500 PSI
Water Absorption: 0.05%
Features: Frost-proof, dilute acid and alkali resistant, salt-proof

Product Usage Instructions

Concrete Encasement Installation

Consult local codes for required concrete encasement depth and width.
Ensure proper expansion and contraction control joints and reinforcement for protection.
Add an additional 4 inches of concrete encasement after the end cap if there is a vertical outlet at the end of the run.
Finish the concrete surround level 1/8 – 3/16 inches above the top of the channel edge.

General Installation Guidelines

Verify the trench drain model as MONO 100 (SPORT) by VODALAND or an approved equal.
The trench drain channels should be 39.4 inches long with a nominal clear opening of 4 inches and overall width of 5.5 inches.
The grate opening should be monolithically cast as a part of the trench drain body as a single piece.
The channels and grate should withstand the required EN1433 load class.

Maintenance and Warranty Information
Ensure complete drainage system installation by VODALAND CANADA INC. Any deviation or improper installation may void warranties provided by the manufacturer.

FAQ

What should I do if my trench drain system has a vertical outlet at the end of the run?
You need to add an additional 4 inches of concrete encasement after the end cap to ensure proper installation.
What are the key material properties of the MONO 100 (SPORT) trench drain?
The trench drain is made of polymer concrete with compressive strength of 14,000 PSI, flexural strength of 4,000 PSI, and tensile strength of 1,500 PSI. It is also water-absorption resistant, frost-proof, dilute acid and alkali resistant, and salt-proof.

4” (100mm) MONO POLYMER CONCRETE TRENCH DRAIN

Dimension

NOTES:

SPECIFIER IS RESPONSIBLE FOR CONCRETE ENCASEMENT AND REINFORCING BASED UPON APPLICATION AND LOCAL CODES.
EXPANSION AND CONTRACTION CONTROL JOINTS AND REINFORCEMENT ARE RECOMMENDED TO PROTECT CHANNEL AND CONCRETE SURROUND. ENGINEERING ADVICE MAY BE REQUIRED.
THIS INSTALLATION SCHEME IS A RECOMMENDATION. CONSULT WITH THE MANUFACTURER FOR INSTALLATION INSTRUCTIONS.
IF TRENCH DRAIN SYSTEM HAS A VERTICAL OUTLET AT THE END OF THE RUN, IT IS NECESSARY TO ADD AN ADDITIONAL 4” (100mm) OF CONCRETE ENCASEMENT AFTER THE END CAP.
THE FINISHED LEVEL OF CONCRETE SURROUND SHOULD BE 1/8” – 3/16” (3-5mm) ABOVE THE TOP OF THE CHANNEL EDGE.

GENERAL:
THE TRENCH DRAIN SHALL BE VODALAND CANADA MONO 100 (SPORT) AS MANUFACTURED BY VODALAND OR APPROVED EQUAL.

SPECIFICATION:
CHANNELS SHALL BE 39.4” (1000MM) LONG AND THE NOMINAL CLEAR OPENING SHALL BE 4” (100MM) WITH 5.5” (140MM) OVERALL WIDTH AND BUILT IN NEUTRAL SLOPE AS PER SPECIFIER’S REQUIREMENTS. EACH UNIT WILL FEATURE A FULL RADIUS IN THE TRENCH BOTTOM AND FEATURE MALE-TO-FEMALE INTERLOCKING JOINTS. GRATE OPENING SHALL BE MONOLITHICALLY CAST AS A PART OF THE TRENCH DRAIN BODY AS A SINGLE PIECE. CHANNELS AND GRATE SHALL WITHSTAND A REQUIRED EN1433 LOAD CLASS.

MATERIALS
MONO 100 (SPORT) TRENCH DRAIN SHALL BE MANUFACTURED FROM POLYMER CONCRETE WITH THE FOLLOWING APPROXIMATE PROPERTIES:

COMPRESSIVE STRENGTH 14,000 PSI
FLEXURAL STRENGTH 4,000 PSI
TENSILE STRENGTH 1,500 PSI
WATER ABSORPTION 0.05%
FROST PROOF YES
DILUTE ACID AND ALKALI RESISTANT YES
SALT PROOF YES
THE COMPLETE DRAINAGE SYSTEM SHALL BE BY VODALAND CANADA INC. ANY DEVIATION OR PARTIAL SYSTEM DESIGN AND/OR IMPROPER INSTALLATION WILL VOID ANY AND ALL WARRANTIES PROVIDED BY VODALAND CANADA INC.

CHECK AND SPECIFY APPROPRIATE OPTIONS:

| Name| Article| Н, in| H, mm
---|---|---|---|---
| 4” MONO polymer concrete endcap H7.9” (end)| 67019-5K| 7.9| 200
| 4” MONO polymer concrete endcap H7.9” (beginning)| 67019-5N| 7.9| 200