microSHIFT FC001-003 SWORD Crankset 1×10-speed Instruction Manual

July 3, 2024
microSHIFT

microSHIFT FC001-003 SWORD Crankset 1×10-speed

FAQ

Frequently Asked Questions

  • Q: What should I do if I encounter play between the spindle and bottom bracket bearings after installation?
    • A: Tighten the preload bolt further, ensuring not to exceed 3Nm. Check for play by rocking the crank arms side to side.
  • Q: How do I contact customer support for assistance with installation?
    • A: Please contact us at www.microSHIFT.com or consult with a professional bicycle mechanic for any installation queries or issues.

Important Notice

REMINDER

Before installing the products, please read and understand the installation procedures. Improper installation can lead to premature product failures or even injuries. If you have any questions on how to install, please contact us or consult with a professional bicycle mechanic.

This installation applies to the 1x and 2x SWORD cranksets

Tools and Supplies

  • Torque Wrench
  • 5mm Hex Bit
  • 5mm Hex Wrench
  • 8mm Hex Wrench

Crank Arm Installation

  • Apply a thin layer of grease to the bearing seats on the spindle.
  • Slide the crank through the drive sidev bottom bracket.
  • Slide the left side crank arm onto the spindle.
  • The crank includes a washer that goes on the preload bolt. Make sure the washer is on the preload bolt.
  • Thread the preload bolt into the spindle with your 8mm hex wrench.
  • The preload bolt is for removing play between the spindle and bottom bracket bearings. Lightly tighten the preload bolt until there is no play between the spindle and bottom bracket bearings and no further, about 1-3Nm.Check for play by rocking the crank arms side to side. If play exists, tighten the preload bolt further. Do not exceed 3Nm.
  • Tighten both crank arm pinch bolts to 12-15Nm. Alternate between bolts as you tighten them.
  • Apply grease to the threads of the right pedal and thread the Right pedal into the right crank arm clockwise. Torque to 31-34 Nm.
  • Apply grease to the threads of the right pedal and thread the Right pedal into the right crank arm counterclockwise. Torque to 31-34 Nm.

www.microSHIFT.com

© 2024 microSHIFT |AD-II Engineering Inc.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals