NICREW Hyper Reef Aquarium LED Light Instruction Manual
- August 27, 2024
- NICREW
Table of Contents
HyperReef LED Light
Instruction Manual
Important Safety Instructions
WARNING – To guard against injury, basic safety precaution should be
observed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
- DO NOT look directly at LEDs regardless of intensity.
- DO NOT SUBMERGE THE LAMP UNIT. The light is NOT WATERPROOF; water can permanently damage it. This damage is NOT covered under warranty.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if it is dropped or damaged in any manner.
- Ensure your hand is dry when turning the power switch on/off and when inserting/removing the power cord from the receptacle.
- A G.F.C.I (Ground fault circuit interrupter) & surge protector is recom mended for all electrical appliances.
- Ensure the fixture is securely installed before supplying power to the unit.
- Always leave a drip-loop in the DC supply cable to the lamp unit to prevent water running down the cable and reaching the PSU (fig. 1).
What’s in the Box
1 x LED Light Unit
1 x Power Supply
1 x Tank Mount
1 x Instruction Manual
Control
Tap: Touch and remove finger quickly
Hold: Press and hold the button
M: ON/OFF, cycle through different light modes
W: Adjust white channel light intensity
B: Adjust blue channel light intensity
- Tap the Mode button marked “M” to turn on the lights.
- Tap the M button to select one of the 3 modes: All LEDs on, Only Blue Channel on, or Only White Channel on.
- Tap W or B button to adjust the corresponding intensity levels for each channel.
- Hold the M button for 3 seconds to turn all LEDs off.
- Tap the M button again and it will resume to last mode set.
NOTE:
There are 6 intensity levels to choose from in each channel: 5%, 20%, 40%,
60%, 80%, 100%.
Installation
- Place the power supply in a dry ventilated area. Include a “drip loop”.
- Assemble the tank mount as instructed (fig. 2).
- Mount on the rear wall of the tank.
NOTE:
- The light fixture must be fastened securely so that it cannot accidentally be dislodged from its mounting.
- The top surface and sides must have unrestricted airflow for correct heat dissipation.
- Mounting the light a minimum of 6 inches (15 cm) above the surface of the water is recommended.
For Hanging Option
Screw hanging kit into the center hole and secure the hanging wire to the
ceiling or other mount.
NOTE:
The higher you hang your light over the water, the wider the light spread –
but the lower the light intensity. Wider and/or deeper tanks may require
hanging more than one LED light in order to provide sufficient light coverage.
Compatibility
For HyperReef 50, 100 and 150
Multiple lights can be daisy-chained for control by external controller.
Connect two or more lights with the unit link cable (3.5mm 4-pin connector
cable, not Included), see (fig. 3). Disposal Information (for EU countries
only)
The symbol shown as follows, applied to the product or on its package, at the
end of life, the product must not be thrown away, or disposed into domestic
waste!
Warranty
NICREW products carry a one-year limited warranty from the date of purchase.
If your product is within warranty and you require a replacement part or
service, please contact us at support@nicrew.com.
For more information, please visit www.nicrew.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>