NICREW Hyper Reef Controller Instruction Manual
- August 27, 2024
- NICREW
Table of Contents
NICREW Hyper Reef Controller
Safety Instructions
- DO NOT use a power supply outside the specifications.
- DO NOT use outdoors. This unit is intended for indoor use only.
- DO NOT expose the unit to an extremely humid environment or submerge the unit in water. This may lead to unit failure.
- DO NOT mount over open water.
- ENSURE that the back plate is correctly mounted to a steady surface. Incorrect mounting can result in detachment of the plate and controller.
What’s in the Box
- 1 x HyperReef Controller
- 2 x Screws
- 2 x Nylon Anchors
- 1 x Magnetic Back Plate
- 2 × 3.5mm TRRS Cables
Navigation
Get Started
Step 1: Power
- Insert the 3.5mm TRRS cable into the light fixture.
- Plug the other end to the controller port.
Alternative
- For third-party light fixtures, plug the Type-C cable into the USB Type-C slot and a 5V/1A USB power adapter. (USB power adapter and Type-C cable are not included.)
- The HyperReef controller can be powered off through HyperReef 50, 100, and 150 if the controller is not connected to a 5V/1A USB power adapter.
Step 2: Set Up
- Use the Direction Pad to navigate to the Setting tab.
- Press to accesses the setting.
- Press to return to the Dashboard.
Step 3: Manual Configuration
- Navigate to the Manual tab by pressing the button.
- Press to access manual mode.
- Press to select the lighting bar, and press to set the light intensity.
- Press to return to the tab options.
Step 4: Program
- Navigate to the Program tab.
- Press to accesses the program’s settings.
- Press to navigate between preset programs or new programs and press to enter.
- Press to choose the time point and press to enter for detail settings.
- Press to navigates between functional settings.
- Press and then press to adjust the value.
- Press to returns to the tab options.
- NOTE: Make sure to save when finished.
Step 5: Mode Set
- Navigate to the Mode Set tab.
- Press to access the lighting mode selection.
- Press to select the desired lighting schedule.
- Press to return to the tab options.
Step 6: Mounting
- Use the screws provided to mount the magnetic back plate to a wooden surface.
- If mounting to a wall, pre-drill two 6mm holes and insert nylon anchors before screwing the plate in.
Disposal Information (for EU countries only)
- The symbol shown as follows, applied to the product or on its package, at the end of life, the product must not be thrown away, or disposed of into domestic waste!
Limited Warranty
- NICREW products carry a 12-month limited warranty from the date of purchase. If your product is within warranty and you require a replacement part or service, please contact us at support@nicrew.com.
- For more information, please visit www.nicrew.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>