NICREW Power Vac Plus Automatic Gravel Cleaner Instruction Manual
- August 27, 2024
- NICREW
Table of Contents
NICREW Power Vac Plus Automatic Gravel Cleaner
Introduction
- With its intelligent 3-in-1 design, the Automatic Gravel Cleaner combines the gravel cleaner, water changer, and waste remover system for quick and easy cleaning with no siphoning or annoying mess to clean up.
- The powerful pump sucks the dirty water from the bottom via the suction nozzle into the sponge filter element, the dirt particles are reliably caught and removed from the water.
- Use this tool to thoroughly clean the surface of the gravel at regular intervals and remove the dirt particles around plant roots, stones, and corners.
Parts Listing
NO. | Parts Listing |
---|---|
① | Sure-Grip Handle |
② | Flow Adjustment Valve |
③ | Connector |
④ | Telescopic Pipe |
⑤ | Motor |
⑥ | Rotor |
⑦ | Impeller Cover |
⑧ | Suction Nozzle |
⑨ | Extension Nozzle |
⑩ | Duckbill Suction Nozzle |
⑪ | Pipe |
⑫ | Sponge Filter |
⑬ | Screw Nut |
⑭ | Filter Connector |
⑮ | Nut |
⑯ | Water Outlet (Water Change Feature) |
Specifications
- Input: 120V 60Hz
- Maximum Flow Rate: 210 GPH
- Power: 16W
- Cable Length: 7.8 ft.
Precaution
- Ensure that the water pump is only operated under water so that the impeller does not run dry.
- Always unplug or disconnect all appliances in the aquarium from the electricity supply before placing hands in water or performing aquarium maintenance.
- Drip Loops should always be used to help prevent water from traveling along the cord and coming into contact with an electrical outlet.
- The in-line cord switch is not waterproof. If it falls into the water, unplug it immediately and then let it fully dry.
- The pump must be positioned below the motor start-up water line before starting it.
3 in 1 Cleaner
Gravel Cleaner: For quick on-the-spot cleaning
- Connect suction nozzle 8 to the unit. Depending on the aquarium depth, you can choose to attach the extension nozzle 9 to the suction nozzle for deeper aquariums.
- Connect the sponge filter element to the unit and secure it with the nut 15 provided as fig. 1 shows
- Insert the unit in the aquarium and turn it on. Move the cleaner gently back and forth along the bottom of the aquarium. You can use the telescopic pipe * to adjust to any height.
- Work gravel cleaner so that a continuous flow of gravel is picked up and returned to the bottom, moving to new areas as water changes from cloudy to clear.
Cloudy Water
- It’s normal for your water to appear “not so clear” after a gravel vacuum and everything has been stirred. It should clear within 24 hours or less with good filtration.
- If you have live plants, we suggest that you vacuum very gently over the top of the gravel. If you have large ornaments, please remove them from time to time and again vacuum lightly.
Fish Waste Remover: For complete aquarium maintenance
- Connect duckbill suction nozzle 10 to the unit as fig. 2 shows.
- Insert the unit in an aquarium and turn it on. The system will suck fish waste into the filter element while filtering out the water.
Water Changer: Eliminate waste inside your aquarium
- Remove the sponge filter element and connect water outlet 16 to the unit. Then connect one end of the hose to the unit as Fig. 3 shows. Ensure the other end of the hose is placed inside a bucket.
- Insert the unit in the aquarium and turn it on. The Siphon action will automatically start.
- Rubber washers included
Tips
- Use rubber washers (1) to help prevent leaking water by providing a positive seal.
- Cord clamps are used to fixate the power cord on the extension tube.
- The flow rate can be adjusted with the Flow Adjustment Valve.
- If the pump impeller in this cleaner is clogged with debris, please unplug and take out the device, loosen the impeller nut, and pull the impeller cover out, then you can clean debris from inside.
- After using it in marine water thoroughly rinse out the cleaner with tap water.
- This sponge filter should be cleaned/changed regularly.
- If the suction nozzle is filled with too much gravel, lift the unit off the gravel in case of pump clogging.
Disposal Information (for EU countries only)
- The symbol shown as follows, applied to the product or on its package, at the end of life, the product must not be thrown away, or disposed of into domestic waste!
Warranty
1-YEAR LIMITED WARRANTY
- This Automatic Gravel Cleaner is guaranteed against defects in material or workmanship under normal aquarium usage and service for 1 year.
- The guarantee is limited to the repair or replacement of the unit only and does not cover any consequential loss or damage to livestock or personal property irrespective of the cause thereof.
- This warranty does not apply to any unit that has been subjected to misuse, negligence tampering, or commercial use.
- No liability is assumed for loss or damage to livestock or personal property irrespective of the cause thereof. This does not affect your statutory rights.
Contact Us
- If there is any quality-related issue with this product, please contact customer service at support@nicrew.com.
- For more information, please visit www.nicrew.com.
Read User Manual Online (PDF format)
Loading......