lucoro FMAMP600 600 Watt FM RF Amplifier Owner’s Manual
- June 9, 2024
- lucoro
Table of Contents
lucoro FMAMP600 600 Watt FM RF Amplifier
Features
- 600W RF output power
- High gain
- Latest enhancement mode FET RF device Good efficiency
- Reliable operation
Applications
- Power amplifier for exciters
- Independent radio service
- Community radio service
- Reserve back-up
The FMAMP600 is a powerful and rugged 600W RF Amplifier for FM broadcast
systems. Easy to install, it represents unrivalled performance and reliable at
such a low cost.
The front panel display shows systems status, forward and reflected power
levels, plus amps voltage and temperature. These are also available on the web
page interface, and con be accessed from anywhere in the world.
A rear panel TTL control input and status output connector allows for easy
integration into new or existing remote monitoring or control systems, plus
automatic switching in back-up systems.
The FMAMP600’s RF output filter ensures compliance with broadcast regulations.
Specifications
- Dimensions: 2U 88 H x 482 W x 350 D (mm)
- Weight: 5.0kg
- RF input: N female 50ohm
- RF output: N female 50ohm
- Monitor / Control: 9-way D-sub female
- Web interface: Ethernet TCP/IP RJ45
- Frequency: 87.5 – 108MHz
- Output Power: 7W nominal (for full output power)
- Harmonics & spurius: 100 – 600W
- Voltage: -75dBc typical
- Compliance: 100 – 250Vac 50-60Hz EN302018, EN301489
Lucoro Broadcast
www.lucorobroadcast.com
[email protected]
Lucoro Ltd, Clay Pit lane, Bar lane Industrial Estate, Roecliffe, York, YO51
9FS United Kingdom
We reserve the right to alter specifications without notice. E&OE. Photographs
and illustrations are for guidance only and do not form a contract.