Guangzhou GMJ-19 Remote Control User Manual
- August 26, 2024
- GUANGZHOU
Table of Contents
Guangzhou GMJ-19 Remote Control
Important Information
- The main controller of the remote control is NS-021-RF01, responsible for detecting button control data transmission, and the maximum power output of the remote control is 0dBm;
- Press the button to send the data code once and keep sending it for a long time;
- The wireless 433 transmission chip uses a 13.560MHz crystal oscillator, which is sent out through an antenna after matching with the network;
- Wireless data transmission uses a customer defined protocol with a bitrate of 0.6K.
- The remote control is powered by two Dry cell.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>