Guangzhou Kakanuo Technology Co Ltd GY-RC01 Remote Control Instruction Manual
- June 1, 2024
- Guangzhou Kakanuo Technology Co Ltd
Table of Contents
Guangzhou Kakanuo Technology Co Ltd GY-RC01 Remote Control
Remote Control Function Description
Remote Control Function Description
| No.| Function| Description
0| Indicator light| Press any button, the indicator light will turn red.
1| Timer| Press the button to schedule for 1 hour.
2| ON/OFF| On/Off button.
3| Brightness increase| Maximum brightness of 100%,long press or tap the
button to adjust the brightness.
4| Color temperature decrease| Yellow light, long press or tap the button to
adjust the
5| Neutral light| Natural Light.
6| Color temperature rise| White light, long press or tap the button to adjust
the
7| Brightness decrease| Minimum brightness of 5%,long press or tap the button
to adjust the brightness.
8| Color temperature range| Tap the button to change light, Yellow light-
Natural Light- White light.
9| Night light mode| Tap the button to night light scenario.
10| Feeding mode| Tap the button to feeding scenario.
11| Office mode| Tap the button to office scenario.
12| Reading mode| Tap the button to reading scenario.
| |
|
- 2×AAA batteries were installed in the remote, and ensure that the light bulb is powered on and light up.
- Using the remote control to operate towards the light bulb.
- If the remote can not control the bulb, please try to reconnect remote to the bulb as following step:
After the bulb turn on, long press the remote’s on/off button within 3 seconds until the bulb flashes
FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
IC Warning
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Canadian ICES-003 and RSS-210.
Radiation Exposure: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.IC Radiation Exposure Statement .
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>