Guangzhou Hobart Lights T1 LED Wireless Tail Lights Instructions
- June 3, 2024
- Guangzhou Hobart Lights
Table of Contents
Guangzhou Hobart Lights T1 LED Wireless Tail Lights
Content
Battery charging
Installation
Pairing
Testing
Mounting
Battery
- Check the charge status of the batteries before using them and charge them if necessary
- Check the light functions before using the vehicle or machine
- Charge the batteries every 2-3 months when you are not using them
- Replacement lights and additional lights must be paired before use
Match Code Instructionl
The product was paired before it went out. However, if the pair is not
connected due to special reasons, please follow the following instructions to
re-pair.
This product uses wireless 2.4 GHz technology to send and receive commands.
One transmitter can control multiple lights at the same time, while one light
can only receive signal from one transmitter. If you need to replace the
emitter and one of the lights or want to add an additional light, you must
perform the following steps to code the implementation between the emitter and
the same type of light.
Repair
-
Insert the transmitter part into the 7-pin socket, turn on the power of the vehicle running lights.
-
After pressing the power switch of one of the lights, you must press the code switch button on the top of the transmitter within 3 seconds, the transmitter and the light match the code within 5 seconds, if the adjustment is successful, the tail light will light up. Otherwise, repeat the above steps again.
- When you need to match another lamp, repeat step 2.
- Now you can use the wireless tail light set.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>