Wi-Tek WI-AP718M AC1200M Outdoor Mesh Access Point Installation Guide
- June 3, 2024
- Wi-Tek
Table of Contents
AC1200M Outdoor Mesh Access Point
Installation Guide
WI-AP718M
AC1200M Outdoor Mesh Access Point
Quick Install Guide
Package content
Mounting
1. Route the Network cable through
the hole on the back of the holder.| 2. Connect the cable to the Port.
3. Put the device on the mounting Bracket, rotate it in
the direction shown in the figure, and then fix the
connection by tightening the socket head cap screws.| 4. Open the Metal Strap
and pass it through the
two slots of the square clip code, then wind the
metal strip around the rod.
ATTENTION
Make sure that the air bubble stays in the midof the
gradienter after installation.
Overview
| LED | Description |
|---|---|
| PWR | On: the device is powered up. |
Off: the device is powered off.
SYS| On: the device is running normally.
Off: the device is running abnormal.
2.4G| On:Wi-Fi or Mesh is normally
Off:Wi-Fi or Mesh is abnormal
5G| On:Wi-Fi is normally
Off:Wi-Fi is abnormal
Setup new Master AP
Please connect devices according to the above topology.
Follow the steps for quick Master AP configuration, using initial setup wizard:
Connect your PC to device via Ethernet
Step 1 Launch your web browser then enter the device IP address in the
Step 2 address bar and specify the default login key: admin.
Note : In case the device is unable to obtain IP address from a DHCP
server, it will fallback to the default static IP 192.168.1.88.
Step 3 Choose the device operating work mode AP and click NEXT button
Step 4 Choose the device operating protocol DHCP Client and click NEXT button
Step 5 Enter specify the SSID and Key of the wireless network and click. NEXT button
Step 6 Click COMPLETE button to end the quick setup
Adding a new Managed AP
Step 1 Click Add Edge AP button to jump to the Mesh settings page.
Step 2 Click Find new router button to Search for new AP
Add Edge Router
Please make sure that the router to be added has not been used. Power on the router and wait for the router to start until the wireless indicator light is on.| After the wireless indicator light is on, please briefly press the “QuickConnect” button, or connect router wired Ian port together
If the indicator light is not on, please contact customer service
Step 3 Click Finish button to added managed AP
Warranty Card
Username|
---|---
Address|
Telephone No.|
Purchase Shop|
Purchase Address|
Product Model NoPurchase Time|
Serial No.|
Dealer Signature|
- If the product defects within three months after purchase, we will provide you a new product of the same model.
- If the product defects within the three-year warranty period, we will provide the professional maintenance service.
- Proof of purchase and a complete product serial number are required to receive any services guaranteed as part of the limited warranty.
- Any other defects that are not caused by workmanship or product quality, such as natural disaster, water damage, extreme thermal or environmental conditions. stickedamaged, warranty card losing will disqualify the product from limited warranty.
| |
---|---|---
http://support.wireless-tek.com/| http://cloud2.wireless-tek.com|
http://www.wireless-tek.com/
Wireless-Tek Technology Limited
Address: Room 402 4F, BiaoFan Technology Building, Bao’An
Avenue, FuYong Town, Bao’An district, ShenZhen
Website: www.wireless-tek.com
Tel:86-0755-32811290
Email: [email protected]
Technical Support: [email protected]