AENO AEG0001 Electric Grill User Manual
- June 10, 2024
- AENO
Table of Contents
AENO AEG0001 Electric Grill
Product Information
The AENO EG1 Electric Grill is designed to cook various meat and fish dishes.
It comes with removable plates (2 pcs.), a plastic drip tray, quick start
guide, and warranty card. The removable plates are interchangeable and
reversible, with one surface ribbed and the other flat. The device should be
installed on a flat and stable heat-resistant surface in a well-ventilated
area. The grill’s cover panel must be closed before connecting it to the
mains. After cooking, the cooked food shall be removed from the grill using
wooden or heat-resistant spatula only. The non-stick coating should not be
damaged with a sharp fork or knife. The device should not be repaired on your
own if the cord is broken.
AENO EG1, EG1-UK Electric Grill is designed to cook various meat and fish
dishes.
Product Usage
- Place the grill on a flat and stable heat-resistant surface in a well-ventilated area.
- Before connecting to the mains, close the grill’s cover panel.
- Oil the removable plates with a thin layer of cooking oil using a paper towel before using them for the first time.
- Make sure that the drip tray drain is facing backward while installing the plates.
- Select one of the three heating modes: Both Grill (using both cooking plates), Upper Grill (using the upper cooking plate only), or Lower Grill (using the lower cooking plate only).
- Adjust the temperature and time settings by pressing the respective Up and Down buttons next to the temperature and time indicators on either side of the display.
- Press the Start button to preheat the device. Do not put any food products into the grill during preheating. Wait until an audible signal sounds for 5 times to indicate that preheating is done.
- Open the grill and place food products on the lower removable plate. Close the grill.
- After cooking, remove the cooked food from the grill using a wooden or heat-resistant spatula only.
Specifications
- Power supply voltage: AC220–240 V
- Frequency: 50/60 Hz
- Power: 2000.0 W
- Cooking surface area (L × W): 320mm × 220mm
- Operating temperature of cooking plates: 80°C to 230°C
- Opening angle: 40° to 130° (optional opening), 180° (full opening)
- Cooking time for a 15mm thick steak: 5min
- Drip tray: Plastic
- Removable plates: Reversible
- Weight: 5.08kg
Package Contents
- AENO Electric Grill
- removable plates (2 pcs.)
- plastic drip tray
- quick start guide
- warranty card
Limitations and Warnings
Children and people with disabilities may only use the grill under the
supervision of adults or people with an adequate level of experience in using
the device. Keep the grill out of the reach of children. The grill’s surface
becomes very hot during operation, and food products may emit steam or
splashes of oil. The grill’s cover panel ❷ shall only opened by the handle ❶
(See Figure a).
The plastic drip
tray ❽ (See Figure b) is installed inside the grill’s body ❺ on a special
plate ❾: You should move the grill carefully if there is hot grease in the
drip tray. Do not remove the drip tray from the grill’s body until the
appliance is cooled down. Do not touch the the grill’s casing with hands; use
heat-protective gloves when operating the grill. Do not use the grill
outdoors, and keep it away from sources of heat, direct sunlight, open fire or
high humidity, as well as never operate it with wet hands. Always unplug the
grill when it’s not used for cooking. Do not immerse the device in water or
other liquids. If the grill falls into water, you must unplug it first, and
only then remove it from water with gloved hands. Never use the grill if it’s
damaged or its power cord is broken. Do not try to repair the device on your
own. Always install the grill on a flat and stable heat-resistant surface in a
well-ventilated area. If the grill contains too many food products at once, so
it can hardly be closed, never use force to close it as you may damage the
device. To avoid fire hazard, never leave the switched-on device unattended.
The grill’s cover panel ❷ must be closed before connecting it to the mains.
After cooking, the cooked food shall be removed from the grill using wooden or
heat-resistant spatula only. Do not use a sharp fork or knife to remove food
products from the grill as this may damage its non-stick coating.
Initial Setup
Unpack the grill and reel out its cable, but do not plug it into the mains socket. Make sure that the drip tray ❽ is installed on the plate ❾ (See Figure b) at the rear of the grill’s body ❺ (See Figure a). Press the upper lock button ❹ to remove the upper removable plate ❼, and then press the lower lock button ❹ to remove the lower removable plate ❻ by simply pulling it. Wash the removable plates in warm soapy water, and then wipe them dry with a soft cloth. These parts can also be washed in the dishwasher. Please note that plates should be washed and dried after each cooking operation. Install both the upper and the lower grill plates back in place before use. Put the grill on a flat and stable heat-resistant surface.
NOTE that removable plates are interchangeable and reversible. One surface of the plate is ribbed, and the other is flat. Food products can be cooked on any of the above surfaces. While installing, make sure that the drip tray drain ❿ is facing backwards, because the grease must be drained away into the drip tray ❽. When used for the first time, removable plates shall be oiled with a thin layer of cooking oil using a paper towel. If necessary, oil the surface again to ensure proper operation of the non-stick coating. For the first time, the device shall be heat up without food products for about ten (10) minutes. A small amount of light smoke or odor is deemed to be normal and harmless.
Operation
Close the grill. Plug it into a mains socket. You will hear an audible signal, and all LEDs will flash and go out on the control panel ❸. The “OFF” message will be displayed on the digital display (See Figure c) in the middle of the control panel.This means that the grill is in a stand-by mode, and that it is not heating up. Then, you should select one of the three heating modes with the buttons, namely: “Both Grill” meaning the use of both cooking plates, “Upper Grill” meaning the use of the upper cooking plate only, or “Lower Grill” meaning the use of the lower cooking plate only. The display will show the default temperature and the heating time, or the latest settings thereof. Such settings may be changed by pressing the respective “Up” and “Down” buttons on either side of the display next to the temperature and time indicators.
NOTE that you can change the temperature and the heating time right during the cooking by pressing “Up” and “Down” buttons. While in the stand-by mode, you may change the temperature scale from °C to °F by pressing these temperature adjustment buttons simultaneously.
Preheating. Press the “Start” button. The “PRE” message will be
displayed. After preheating is done, an audible signal will sound for 5 times.
NOTE that food products must not be put into the grill during preheating.
Cooking. Open the grill and place food products on the lower removable plate.
Close the grill.
NOTE that you may cook pizza or fish on the open grill (See Figure d) so
as to keep its shape intact, or you may cook steak or sausage in the closed
grill. Press the “Start” button. The current temperature will be displayed,
and the countdown timer will be started.
NOTE that is you do not press the “Start” button, the grill will be
switched to the standby mode in 30 minutes, and the “OFF” message will be
displayed. At the end of the countdown, an audible signal will sound for 5
times. The “DONE” message will be displayed.
See below the LED indication of the grill’s modes (See Figure c):
LED colour Grill mode
- Blue Preheating is on
- Green Preheating is finished
- Yellow Cooking is on
- Red Cooking is finished
When you finished with cooking, press the “Cancel” button and unplug the grill. Wait for the grill to cool down, then carefully remove the drip tray ❽ and pour its contents down the drain. Don’t forget to wash the removable plates and the drip tray with warm soapy water.
Troubleshooting
- The grill does not turn on. Possible causes and solutions: Make sure that there is no power supply failure in the mains socket (e.g. plug any known good device into it) and that the grill is correctly plugged into the mains socket.
- The grill is switched on, but removable plates do not heat up. Possible causes and solutions: Make sure that you set both the operating time and the temperature and that the “Start” button was pressed.
- The control panel does not light up. Possible causes and solutions: Unplug the grill, let it cool down, and plug it in again.
Table of error codes displayed on the display:
Error code Value
- Е1 Upper thermostat contact breakage
- Е2 Upper thermostat short-circuit
- Е3 Lower thermostat contact breakage
- Е4 Lower thermostat short-circuit
ATTENTION! If your problem persists, please contact your local supplier or the service center for support. Please do not disassemble the device or try to repair it on your own.
Recycling information
These symbols indicate that you must follow the Waste Electrical and
Electronic Equipment (WEEE) and Waste Battery and Battery Regulations when
disposing of the device, its batteries and accumulators, and its electrical
and electronic accessories. According to the rules, this equipment must be
disposed of separately at the end of its service life.
Do not dispose of the device, its batteries and accumulators, or its
electrical and electronic accessories together with unsorted municipal waste,
as this will harm the environment.
To dispose of this equipment, it must be returned to the point of sale or
turned in to a local recycling facility. You should contact your local
household waste disposal service for details. ASBISc reserves the right to
modify the device and to make edits and changes to this document without prior
notice to users. The warranty period and service life shall be 2 years as from
the date of purchase of the device.
Manufacturer: ASBISc Enterprises PLC, Iapetou, 1, Agios Athanasios, 4101
Limassol, Cyprus. Made in China. For current information and details on the
device description and specification, as well as connection process,
certificates, warranty, and quality issues, see relevant Installation and
Operation Manuals available for downloading at
aeno.com/documents. All trademarks and names
herein are the property of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>