Wi-Tek WI-AP310 Cloud Managed Outdoor Wireless Access Point Installation Guide

Wi-Tek WI-AP310 Cloud Managed Outdoor Wireless Access Point

Cloud-Managed Wireless Outdoor Access Point

Package Content

Interface and Indicators

• LED indicator instructions

Ports Instructions

Typical Connection

• Cloud management mode
• AC Gateway mode topology

Device installation

Please prepare a long enough network cable to connect the POE adapter and AP. Recommend to use a Category 5 (or above) shielded network
cable with a ground wire.

• Method 1. Connect computer to the wireless signal of AP, the default SSID is “WI-TEK xxxx”. Password is 88888888

• Method 2. Connect computer to the AP by Ethernet cable.

• Step 1. On the computer, please set the static IP under the same subnet with AP, 192. 168. 1. xx

• Step 2. Please launch a browser such as Google Chrome or Firefox, type 192.168.1.88 into address bar and click on enter to get in the login page of wireless access point. The default login password is “admin”.
  *Login device
  Admin : Login

• Step3. After get in the management page, On the left side menu, please go to [Wizard] to setup the access point

• Step4. Select the appropriate operation mode and follow the instruction of wizard to finish the settings. If already exist a Router in your network, please choose, Fit AP mode; if not, you can choose Wireless Router mode
  Notice: if you do a reset, AP will recovery to Fit AP mode

• Fit AP Mode default Login IP: 192.168.1.88 admin/admin
  

• Wireless Router Mode default Login IP: 192.168.11.1 admin/admin
  

Cloud management settings

• Step 1 Launch your web browser then enter http://cloud2.wireless-tek.com in the address bar.

• Step 2 Register an account password by user name or email.

• Step 3 log in to the cloud account with the account password after registration.
  

• After the login is successful, the steps to bind the device on the cloud account are as follows:

  1. Click ADD NETWORK
     
     

  2.  Fill in the group name and location, click save.

  3. And click next.
     

  4. Enter serial number, click ADD to create and click FINISH ,the configuration is complete.
     Note: The 17-digit SN code of the Add device is shown on the sticker on the back of the device.
     

  5.  In the relevant device options, you can see the bound device information.
     

  6. Click Tunnel, Select binding device type, click EWEB to log in to the device.
     

Warranty Card

Username|
---|---
Address|
Telephone No.|
Purchase Shop|
Purchase Address|
Product Model No.|
Purchase Time|
Serial No.|
Dealer Signature|

• If the product defects within three months after purchase, we will provide you a new product of the same model.
• If the product defects within the three-year warranty period, we will provide the professional maintenance service.
• Proof of purchase and a complete product serial number are required to receive any services guaranteed as part of the limited warranty.
• Any other defects that are not caused by workmanship or product quality, such as natural disaster, water damage, extreme thermal or environmental conditions. sticker damaged, warranty card losing will disqualify the product from limited warranty.

WirelessTek Technology Limited
Address: Room 402 4F, BiaoFan Technology Building, Bao’An Avenue, FuYong Town, Bao’An district, ShenZhen
Website:www.wireless-tek.com
Tel:86-0755-32811290
Email:sales@wireless-tek.com
Technical Support:tech@wireless-tek.com

References

• New Cloud 2.0
• Wi-Tek Cloud
• Test and Measurement Equipment | Tektronix
• Wireless-Tek Technology Limited.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>