K2 PUMPS IRP07501K 1.5 HP Sprinkler Pump User Guide

June 3, 2024
K2 PUMPS

K2 PUMPS - logo

Quick Start Guide
Sprinkler/Centrifugal Pump

Model/Modelo: IRP07501K / IRP10001K
/ IRP15001K / IRP20001K

IRP07501K 1.5 HP Sprinkler Pump

Read your manual for installation, operation, and safety information. This guide neither supplements nor replaces the Owner’s Manual.K2 PUMPS IRP07501K
1 5 HP Sprinkler Pump

Install The Pump

  1. The pump must be connected to a well.
  2. Locate the pump and check valve as close to the water source as possible.

Check Voltage Setting And Connect Power Supply WiringK2 PUMPS IRP07501K
1 5 HP Sprinkler Pump - fig

NOTE: For IRP20001K, the motor is wired for 230 volts only, and have no motor wiring to change.
For IRP07501K, IRP10001K, IRP15001K, you need follow below instruction to choose voltage.

  1. Determine if you have 115 or 230 volt power to the pump motor-look at circuit breaker.
  2. Qualified person must install electrical wiring.
  3. Disconnect power!
  4. Remove the motor end cover.
  5. Dual voltage motors may be set for 115V or 230V.
  6. Use the Motor Switch Setting instructions in the owner’s manual to set the motor to match the power source.
  7. Reinstall motor end cover before turning on power.
    Do Not Turn On Power Yet!

Put Water In The Pump

  1. The pump must be filled with water (primed) before operating.
  2. Install the priming plug.

Open Valves

  1. Open the outlet valve in the outlet line.

Start The Pump Monitor The Pump’s Operation
Water should flow within 5 minutes. If it does not, turn off power and re- prime per step 3.
Once filled, the pump is self-priming. It should not need to be refilled again unless air enters the pump or inlet line. For additional information and troubleshooting, please  consult the owner’s manual.

NOTICE
WARNING Hazardous voltage. Disconnect power before installation.
WARNING Risk of explosion and steam burns. DO NOT run pump with outlet closed.

  • DO NOT run the pump without water, and never operate it with a closed outlet line.
  • DO NOT connect hoses to the pump.
  • DO NOT connect to pressurized supply (city water or other pump’s output).
  • DO NOT reduce the pipe size for inlet or outlet lines.
  • DO have an air-tight inlet line.
  • DO read and follow the instructions in the manual.
  • DO have electrical and plumbing systems installed by qualified persons.

Please contact 1-844-242-2475 for further assistance.
Por favor, llame al 1-844-242-2475 para extra asistencia.K2 PUMPS - logoCopyright © 2020, GP Enterprises Co., Ltd.
K2-IR-1 (Rev. 12/04/20)

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals