K2 PUMPS UTM02501K Duo 2-in-1 Utility Pump User Guide
- June 3, 2024
- K2 PUMPS
Table of Contents
K2 PUMPS UTM02501K Duo 2-in-1 Utility Pump User Guide
Submersible Utility Pump Function
-
Connect the Garden Hose
Attach a 3/4 inch garden hose to the pump outlet. Use a garden hose that is no longer than 25 feet.
-
Plug in the Pump
Place the pump on a hard surface in water that is at least 1-1/2 inches deep. Do not place the pump directly on sand, dirt, or mud. Plug the pump into a properly grounded 115V GFCI outlet. Be sure the plug is secure and will not fall into the water. The pump should start immediately.
-
Operating the Pump
Allow the pump to run and monitor its progress. Unplug the pump when it has removed water down to approximately 1/2 inch.
CAUTION: Do not run the pump dry. Operating the pump without water will cause damage to the seals and will cause the pump to fail, which voids the pump’s warranty.
Non Submersible Transfer Pump Function
-
Connect the Suction Strainer and Suction Hose
Attach the Suction hose included with your pump to the suction strainer. Make sure the gaskets in the Suction hose are airtight or the pump will not pump water.
Lay the pump on its side and open the bottom cover. Attach the other end of the Suction hose to the pump inlet.
-
Attach the Garden Hose
Attach a 3/4 inch garden hose to the pump outlet. Use a garden hose that is no longer than 25 feet. Keep both the Suction hose and Garden hose as straight as possible. The end of the Garden hose should be OUT of the water.
-
Prime the Pump 4. Operating the Pump
Unscrew the priming plug. Fill with water until the suction hose is completely filled and overflowing with water. Tighten the priming plug.
-
Operating the Pump
Place the Suction Strainer on a level surface IN the water. The garden hose and pump should be OUT of the water.
Plug the pump into a properly grounded 115V GFCI outlet. The pump should start within 30 seconds. Monitor the pump’s progress and unplug the pump before it runs dry.
NOTE: If the pump is not pumping water in 30 seconds, unplug the pump. Check the connections on the two ends of the Suction hose to make sure there are no air leaks. Repeat the priming instructions.
