Westinghouse 62278 Wall Light Fixture Instruction Manual

: June 3, 2024
: Westinghouse

Table of Contents

Westinghouse 62278 Wall Light Fixture
Instruction
ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE
MOUNTING AND WIRING INSTRUCTIONS
CLEANING AND CARE
- Meaning of crossed-out wheeled dustbin
Appliance specifications – TECHNICAL CHARACTERISTICS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Westinghouse 62278 Wall Light Fixture

Instruction

WARNING: ELECTRICAL SHOCK CAN RESULT IN SERIOUS INJURY.
Read and follow instructions exactly as shown. If instructions are unclear, do not proceed. Contact a qualified electrician. Read all instructions before beginning. Proper wiring is essential for safe operation of this fixture. When cutting or drilling into walls or ceilings, do not damage electrical wiring, gas lines, or water lines. If any of the fixture or wiring components are dam- aged, do not install fixture. Return to place of purchase.

ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE

Congratulations on your Westinghouse purchase. This fixture has been designed to give you many years of beauty and service. For questions and comments, please visit www.westinghouselighting.eu/contact- us and www.westinghouselighting.de/contact-us
NOTE: Carefully unpack fixture and parts. Make sure all parts are included before discarding any packing materials (see figure 1).

Westinghouse-62278-Wall-Light-Fixture-1

MOUNTING AND WIRING INSTRUCTIONS

NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture.

Turn off power at circuit box to avoid possible electric shock.
Place mounting bar (B) flush against wall at desired mounting location. Using outside mounting bar holes as a guide, mark where pilot holes are to be drilled.
NOTE: Mounting bar must be straight for fixture hanging straight.
Inset two plastic anchors (G) into the pilot holes (for drywall).
Align outside mounting bar holes with plastic anchors (G) (If applicable). Secure mounting bar (B) into place using wood screws (E).
Make an electrical connection by loosening the terminal screws on the terminal block (M) and inserting the live, neutral and ground terminals.
Tighten terminal screws. Make sure there are no stray wires.
Position back plate (C) over mounting screws (A) by aligning back plate openings (F) with mounting screws (A).
Secure with cap nuts (H).
Install glass shade (L) and plate (P) (if applicable) into holder(s) (N). Secure with thumb screws or ring(s) (O), whichever is applicable.
Install lamp (not supplied). (Please do not exceed the maximum capacity recommended on the socket).
Turn power back on at circuit box.

CLEANING AND CARE

To clean, wipe fixture with soft cloth. Clean glass with mild soap. Spray from chemical cleaners can discolor the finish of fixture. Do not use scouring pads, powders, steel wool or abrasive paper to clean this fixture.

Meaning of crossed-out wheeled dustbin

Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact you local government for information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposal at least free of charge.