BORMANN bda1500 INOX 1500W 022602 User Manual
- June 4, 2024
- BORMANN
Table of Contents
BORMANN bda1500 INOX 1500W 022602
Instructions
-
Check the machine when you open the carton. Please reinforce the screw which may be loose during the transportation. Check the bottom disk and drive belt, please adjust the belt if the tightness is not suitable.
-
Put the machine on the flat ground, and let the machine race empty for 3-5 minutes to make sure there is no problem of the machine.
Try to make the cut as small as you can when bleeding the chickens (better to thrust the chicken’s neck with the cone-knife, which will prevent the chicken’s head from dropping off in depilating). After bleeding, put the chicken in warm water 300C—500C,make sure all the feather are wet out, It is better to put some salt into the water which can protect the skin away
from damage. -
Put the wetted chicken in the hot water(750C), churn slowly to hot all the feather
-
Turn on the machine; Put the hot chicken, up to 2 heads at one time. During depilating, please put some water onto the chicken(hot water is better), the feather will be washed away and run out of the machine with the dirty water
-
The feather will be all clear out after 40-60 seconds, turn off the machine and get out the chicken while the machine stops racing.
-
It is better to depilate the chicken immediately after bleeding. The effectiveness will be not good if the chicken stays dead for a long time
Notice
- For your safety, please install a leakage protector and link safety ground line
- Main power supply should be higher than the machine supply
- Never touch the machine with wet hand
Drawing
Technical Data
| Depilation net rate: | 95% |
|---|---|
| Net Weight: | 38Kg |
| Gross Weight: | 42Kg |
| Motor speed: | 275r/min |
| Motor Power: | 1500W |
| Barrel diameter: | 50cm |
| Construction Material: | 403 stainless steel |
| Suitable for (up to 6 kg) : | Chicken, goose, duck |
-
The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the products. The parts described/illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer’s
product line with similar features and may not be included in the product
you just acquired. -
Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
-
To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>