Avail NRCR Series CALIBRE 32mm Diameter Grab Rail Installation Guide

July 23, 2024
Avail

Avail NRCR Series CALIBRE 32mm Diameter Grab Rail

Avail-NRCR-Series-CALIBRE-32mm-Diameter-Grab-Rail-
PRODCUT

STOCK CODES

  • Mod S (300mm) – NRCR3272
  • Mod M (450mm) – NRCR3278
  • Mod L (600mm) – N RCR3224
  • Mod XL (900mm) – NRCR3230
  • Mod XXL (7200mm) – NRCR3248

DIMENSION

Avail-NRCR-Series-CALIBRE-32mm-Diameter-Grab-Rail-
FIG-1

AVAIL QUALITY DESIGNS

  • Australian Owned and Designed
  • Sizes: 300 -1200mm Lengths as standard, longer available by request
  • Available in over 7 finishes including Living Brass, Chrome, Matt Black, Gunmetal, Brushed Nickel, Bronze, Gold
  • Modular design, the rail is to be mounted horizontally, vertically, or at any angle and cut down to suit your bathroom
  • 150 kg capacity for all 32mm diameter caliber grab rails
  • Mod 32mm diameter rails are approved for standard AS1428.l requirements in DOA bathrooms

CONTENTS

Avail-NRCR-Series-CALIBRE-32mm-Diameter-Grab-Rail-
FIG-2

  • 2 x Wall Brackets
  • 4 x Stainless Screws 72g x 50
  • 2 x Grub Screws M6 x 5
  • 7 x Grab Rail

CALIBRE RAIL INSTALLATION INSTRUCTIONS

  1. Locate wall studs, and install them into at least one stud. Place wall seal/mounting bracket on wall at correct height over center of the stud and mark hole positions on the wall
    (minimum 2 supplied screws per bracket).

  2. Drill pilot holes into wall stud approximately 50mm deep to suit mounting screws (and wall plugs if required).

  3. Apply a small amount of silicon to the mounting bracket and wall in and around the screw holes.

  4. Install mounting brackets by screwing them onto wall
    Tip: use appropriate mounting screws for the wall stud material, supplied screws are for timber wall studs, and one larger bugle screw can be used in the center hole.

  5. Slide rail tube into end bracket and push onto wall brackets.

  6. Tip: rail length can be cut down to a smaller size, simply use an angle grinder, hacksaw or pipe cutter then deburr the end with a file or grinder and reinsert into the end bracket.

  7. Tighten grub screws with the Allen key.

  8. Tip: if the rail rattles, loosen the end bracket, twist slightly, and tighten.

Avail-NRCR-Series-CALIBRE-32mm-Diameter-Grab-Rail-
FIG-3

WARNING:
These rails are designed to be mounted onto wall studs or masonry walls. Installation is recommended to be completed by a qualified tradesperson who complies with the AS 7428.7- 2009 Design for Access and Mobility standard. It is recommended rail location is determined by a qualified Occupational Therapist or trained professional to the AS 7428.7-2009 standard. Correct installation is required to ensure safe, long-term operation. Incorrect mounting can result in reduced capacity of the rail which can result in injury to the user and damage to the wall .

MORE INFORMATION

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals