Avail NRCR0001 Liberty DDA Toilet Back Rest Instruction Manual
- July 23, 2024
- Avail
Table of Contents
Avail NRCR0001 Liberty DDA Toilet Back Rest Instruction Manual
Dimension
AVAIL QUALITY DESIGNS
- Australian owned and designed
- High quality, high strength materials and finishes
- Backrest cushion available in satin white or black, standard shape is oval but also available in rectangular upon request
- Wall bracket and rail are available in a range of standard or custom finishes
- Comfortable waterproof cushion
- 110kg capacity in each direction
- AS1428.1 Approved for DAD Bathrooms, see diagram for correct install location
LIBERTY DAD TOILET BACK REST INSTALLATION INSTRUCTIONS
-
Before beginning installation, ensure that the wall is suitable for installing the backrest. Place the wall fixing plate on the wall at the correct height over the centre of a stud and mark hole positions on the wall (refer to above picture).
Tip : The backrest should be installed at a height of 690-710mm above ground level.
-
Drill pilot holes into the wall stud to a depth of approximately 60mm in order to accommodate mounting screws (and wall plugs if necessary).
Tip : Use 3mm hole for screws into timber or 8mm hole for wall plugs.
-
Reapply a small quantity of silicone to the wall fixing plate and the surrounding areas of the screw holes
-
Slide the cover plate onto the rail, followed by inserting the wall fixing plate into the rail and securing it with a washer and grub screw.
-
Tighten the backrest onto rail by washer and screws.
-
Secure the wall mounting plate and rails onto the wall.
-
Reposition the cover plates onto the wall fixing plate and secure them by tightening the grub screw with an Allen key.
-
Finished.
-
Backrest can be removed, if you want. Loosen screws on rails and screws on cover plates. And take off rail and plates.
-
Loosen the screws on brackets (refer to above picture). Then you can take off the backrest.
WWW.AVAIL.DESIGN
INFO@AVAIL DESIGN
1300 945 720