Avail NRCR2524D 25mm Double Towel Grab Rail Instruction Manual

July 23, 2024
Avail

CALIBRE DOUBLE TOWEL GRAB RAIL

Ergo 25mm Diameter Double Towel Rail

STOCK CODES

25mm Ergo 600mm – NRCR2524D
25mm Ergo 900mm – NRCR2530D

Avail NRCR2524D 25mm Double Towel Grab Rail 2
TOP

WALL BRACKET
Avail NRCR2524D 25mm Double Towel Grab Rail 3
FRONT

SIDE

AVAIL QUALITY DESIGNS
  • Australian Owned and Designed
  • Sizes: 600-900mm options with custom sizes available on request
  • Available in over 7 finishes including Living Brass, Chrome, Matt Black, Gunmetal, Brushed Nickel, Bronze, Gold
  • Modular design, the rail to be mounted horizontally, vertically or at any angle and cut down to suit your bathroom
  • 150 kg capacity for all 25mm diameter calibre grab rails
  • Ergo 25mm diameter rails are suitable for heavy duty towel rails and smaller hands, in non-DDA bathrooms

Calibre 25mm Ergo Rail

INSTALLATION INSTRUCTIONS
  1. make hole positions 
  2. 300/450/600/900/1200 mm

| 1. Locate wall studs, install into at least one stud. Place wall seal/mounting bracket on wall at correct height over centre of stud and mark hole positions on wall.
---|---

  1. wall plugs

| 2. Drill pilot holes into wall stud approximately 60mm deep to suit mounting screws (and wall plugs if required).

Tip:4mm hole for screws into timber or 10mm hole for wall plugs.

| 3. Apply small amount of silicon to mounting bracket and wall in and around the screw holes.
Avail Rail 4| 4. Install mounting brackets by screwing onto wall.

Tip: Use appropriate mounting screws for the wall stud material, supplied screws are for timber wall studs.

| 5. Slide rail tube into end bracket and push onto wall brackets.

Tip: Rail length can be cut down to a smaller size, simply use an angle grinder, hacksaw or pipe cutter then deburr the end with a file or grinder and reinsert into the end bracket.

Avail Rail 6| 6. Tighten grub screws with Allen key.

Tip: If rail rattles, loosen end bracket, twist slightly and tighten.

WARNING
These rails are designed to be mounted onto wall studs or masonry walls. Installation is recommended to be completed by qualified trades person who complies with the AS 1428.1-2009 design for access and mobility standard.
It is recommended rail location is determined by a qualified occupational therapist or trained professional to the AS 1428.1-2009 standard. Correct installation is required to ensure safe, long term operation. Incorrect mounting can result in reduced capacity of the rail which can result in injury to user and damage to the wall.

WWW.AVAIL.DESIGN INFO©AVAILDESIGN 1300 945 720

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals