prescolite LBSE-LBSES LiteBox Edge-Lit Direct J-Box Mount Instruction Manual

: June 4, 2024
: prescolite

Table of Contents

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Documents / Resources

LBSE-LBSES LiteBox
Edge-Lit Direct J-Box Mount
Instruction Manual

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

Follow label information and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to the power supply and during servicing or relamping, turn off power at the fuse or circuit breaker. All servicing or relamping must be performed by qualified service personnel. The product must be grounded to avoid potential electric shock or another potential hazard. The product must be mounted in locations and at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from the product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens, or the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition. Fixtures are suitable for use in clothes closets per NEC 410.16(C)(1). Fixtures are not suitable for installation into clothes closet storage spaces as defined by NEC 410.2.

Step 1

Attach J-Box mounting plate (with spring tabs up) to compatible existing J-Box with screws provided.
For Square Apertures: Orient plate with spring tabs parallel to the wall for proper alignment. prescolite LBSE-LBSES LiteBox Edge-Lit Direct J-Box
Mount

Step 2

Make wiring connections using provided wire nuts:

Black	→ Line (Hot)
White	→ Neutral
Green	→ Ground
*Purple	→ 0-10V Dim (+)
*Gray or Pink	→ 0-10V Dim (-)

For 0-10V dimming only.
For LBSES models: Select the desired CCT color temperature (27K/30K/35K/40K) using the switch on the driver.

Step 3

Push wire connections up into J-Box aligning fixture springs with mounting plate spring tabs. Push the fixture to the ceiling to securely snap into place. Do not pinch wires! prescolite LBSE-LBSES LiteBox Edge-Lit Direct
J-Box Mount - Step 3 SAVE THESE INSTRUCTIONS!

© 2020 Prescolite, a division of Hubbell Lighting, Inc. All rights reserved.
701 Millennium Blvd Greenville, SC 29607 / Websitewww.prescolite.com
Technical Support: 888.777.4832
Part No. ….93131012

Documents / Resources

| prescolite LBSE-LBSES LiteBox Edge-Lit Direct J-Box Mount [pdf] Instruction Manual
LBSE-LBSES, LiteBox Edge-Lit Direct J-Box Mount, Direct J-Box Mount, LiteBox J-Box Mount, J-Box Mount
---|---