Avail Design S01SA Toilet Support Arms Installation Guide

Table of Contents

Avail Design S01SA Toilet Support Arms

Avail Design S01SA Toilet Support Arms

NOTE

Please read the instructions carefully to understand our toilet support arms and prepare the necessary tools for installation in advance. Correctly install the toilet arms according to the instructions. This will help avoid hurting you, your family and your property.
Please keep the instructions available after reading it carefully.

Parts

Screwdriver

|

Soft wet cloth

As shown in Figure 1, Toilet Seat applicable to the support arm must satisfy the requirements below:

To prevent interference between the arm rest end and the toilet cistern, the area of A~60mm shall be flat.
Distance between the installation holes in the toilet seat: 130mm~B~200mm.

Assemble the handrail. Fix and tighten the screws to assemble both left-hand and right-hand arms to the fixing plate.
Remove the toilet seat and the fasteners.
Install the supplied screws into the toilet fixing holes.
Place the fixing plate onto the toilet, fixing holes to toilet fixing holes.
Install the fixing plate: install and half-tighten the hinges according to the figure above. (Do not fully tighten the screws)
Install the toilet seat back.
Align the toilet seat to the toilet and fully tighten the fixing screws. ( You may need to take off the toilet seat to fully tighten the screws).
Take off the toilet seat to fully tighten the fixing screws, check seat fits correctly; Put on the hinge covers.
Click the toilet seat back.
Finished.

NOTES

To prevent the lock nut from being pulled out or loosened during use of the arm rest, try to secure the hinge base fixation kit as tightly as possible without causing the nut to be stripped.
To avoid the Toilet Seat from falling to one side, or being tilted up significantly, do not forcefully shake or put excessive pressure (C~80kg) onto one side of the arm rest after the arm rest is correctly installed.
To prevent damage to the lifting handrails, the dual handrails simultaneously bear D ~ 120kg
The figures above are for reference only.

Use a mild detergent such as liquid dishwashing soap and warm water for cleaning. Do not use abrasive or high density cleaners that may scratch or dull the surface.
Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
Wipe surfaces clean and rinse completely with water immediately after cleaner application. Rinse and dry any overspray that lands on nearby surfaces.
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean surfaces.