Princeton Tec VIZZ LED HEADLAMP Installation Guide
- June 6, 2024
- Princeton Tec
Table of Contents
available at BrightGuy.com
VIZZ®
LED HEADLAMP
0219
Operating and Maintenance Instructions
- Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of 0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
Battery Installation – See Figure 1
3 AAA
- Alkaline (LR03)
- Lithium (L92)
- Rechargeable NiCad or NiMH
Princeton Tec cares about the environment and recommends recycling batteries. For more information about battery recycling, please go to www.batteryrecycling.com.
Observe proper battery polarity. Improper installation of the batteries will damage the light and void the warranty.
WARNING!
- Never mix fresh and used batteries.
- Never mix different battery brands or chemistry types.
- Always remove drained batteries immediately.
- Remove batteries during long periods of storage.
NOTE: Lithium batteries offer extended constant brightness time, extreme cold weather performance, and lighter weight. Rechargeable NiCad or NiMH batteries may result in reduced brightness due to lower nominal voltage.
The Vizz battery compartment has a waterproof seal. It is important to keep this seal free from dirt and away from harsh chemicals in order to preserve waterproof integrity. Inspect the seal every time batteries are changed. If dirt is present, wipe gently with a damp cotton swab and mild soap until the dirt is removed.
Switch Operation – See Figure 2
From off:
One press – Red Ultrabright LEDs
Two presses – Maxbright LED
Three Presses – White Ultrabright LEDs
Five-second hold – Lockout
On in any mode: Hold – Dimming Press after more than two seconds – Off A single press more than two seconds after the previous button press will turn the light off.
From off stage, a 5-second hold will lock the light to prevent accidental turn on and resulting battery drain. The Indicator LED (located inside the power button) will blink three times to confirm the lock. 5 Second hold from the locked state will unlock the light and the indicator LED will flash to confirm unlocking. Removal and replacement of batteries will also reset Vizz to the unlocked state.
Troubleshooting
If the Vizz fails to light:
- Check the batteries for proper installation.
- Replace batteries if proper installation is confirmed.
- Check the k circuit board for water (the seal may have been compromised by the improper rear cover installation or dirty seal). The light will resume normal operation once the water is shaken or blown out and the light is left open until completely dry. If the light has been contaminated with salt water, flush the unit with fresh water and dry as described above.
USA Lifetime Warranty – International 10-YearWarranty
Due to International regulations, Princeton Tec’s lifetime warranty can only
be offered to customers in the USA. Princeton Tec offers a 10-year warranty to
our customers outside the USA. FULL WARRANTY – Princeton Tec warrants this
product to be free from defects in workmanship and materials under normal
use for as long as you own this product. This warranty covers all of the
component parts of the product except batteries. This warranty does not cover
deterioration due to normal wear or damage due to misuse, alteration,
negligence, accidents, or unauthorized repair. Princeton Tec will repair or
replace parts that are defective in workmanship or materials. Your authorized
Princeton Tec Dealer and Princeton Tec are the only facilities authorized to
repair the product.
After (3) unsuccessful attempts to repair the product, you have the right to
elect replacement of the product or a refund of the purchase price less
allowance for use of the product. NO INCIDENTAL OR CONSEQUENTIAL DAMAGES ARE
INCLUDED IN THIS WARRANTY. (Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitations or
exclusions may not apply to you.) This warranty gives you specific legal
rights and you may also have other rights which vary from state to state.
Princeton Tec reserves the right to change product specifications without notice.
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A (BPA) a chemical known to the
State of California to cause birth defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
- Check batteries. Replace if necessary.
- To send your light in for repair or replacement, first, contact Princeton Tec customer service on 1-800-257-9080 to request an RMA number. Please have your light model, date of purchase, and a brief description of the fault you are experiencing. No warranty repairs will be accepted without an RMA number.
- Return the light without batteries to Princeton Tec, PO Box 8057 Trenton NJ Postage due and freight collect items will not be accepted.
- Upon receipt, your light will be processed in about two weeks. Please allow additional time for return transportation from NJ.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2019 Princeton Tec
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>