Avail NRCR2512A Mecca 25mm Toilet Roll Rail Instruction Manual
- July 23, 2024
- Avail
Table of Contents
CALIBRE TOILET RAIL
Ergo 25mm Diameter Grab Rail & Toilet Roll Holder
STOCK CODE(S)
25mm Ergo 300 – NIRCP2512A
25mm Ergo 450 – NIRCR2518A
TOP WALL BRACKET
FRONT SIDE
AVAIL QUALITY DESIGNS
- Australian Owned and Designed
- Handy 300mm Rail which doubles as a toilet roll holder
- Left and Right hand available (Can be Installed on either side facing either direction)
- 150 kg capacity for all 25mm diameter calibre grab rails
- Available in over 7 finishes including Living Brass, Chrome, Matt Black, Gunmetal, Brushed Nickel, Bronze, Gold
- Ergo 25mm diameter rails are suitable for heavy duty towel rails and smaller hands, in non-DDA bathrooms
Calibre 25mm Ergo Rail
INSTALLATION INSTRUCTIONS
- make hole positions
- 300/450/600/900/1200 mm
| 1. Locate wall studs, install into at least one stud. Place wall
seal/mounting bracket on wall at correct height over centre of stud and mark
hole positions on wall.
---|---
- wall plugs
| 2. Drill pilot holes into wall stud approximately 60mm deep to suit mounting screws (and wall plugs if required).
Tip:4mm hole for screws into timber or 10mm hole for wall plugs.
| 3. Apply small amount of silicon to mounting bracket and wall in and around
the screw holes.
| 4. Install mounting brackets by screwing onto wall.
Tip: Use appropriate mounting screws for the wall stud material, supplied screws are for timber wall studs.
| 5. Slide rail tube into end bracket and push onto wall brackets.
Tip: Rail length can be cut down to a smaller size, simply use an angle grinder, hacksaw or pipe cutter then deburr the end with a file or grinder and reinsert into the end bracket.
| 6. Tighten grub screws with Allen key.
Tip: If rail rattles, loosen end bracket, twist slightly and tighten.
WARNING
These rails are designed to be mounted onto wall studs or masonry walls.
Installation is recommended to be completed by qualified trades person who
complies with the AS 1428.1-2009 design for access and mobility standard.
It is recommended rail location is determined by a qualified occupational
therapist or trained professional to the AS 1428.1-2009 standard. Correct
installation is required to ensure safe, long term operation. Incorrect
mounting can result in reduced capacity of the rail which can result in injury
to user and damage to the wall.
WWW.AVAIL.DESIGN INFO©AVAILDESIGN 1300 945 720
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>