Avail R01H40-MB Grab Rail with Toilet Roll Holder Instruction Manual
- June 14, 2024
- Avail
Table of Contents
Avail R01H40-MB Grab Rail with Toilet Roll Holder
32mm Diameter Grab Rail & Toilet Roll Holder
STOCK CODE(S)
- 32mm Mod 450 – NRCR3218A
Product Overview
AVAIL QUALITY DESIGNS
- Australian Owned and Designed
- Handy 300mm Rail which doubles as a toilet roll holder
- Left and Right hand available (Can be Installed on either side facing either direction)
- Available in over 7 finishes including Living Brass, Chrome, Matt Black, Gunmetal, Brushed Nickel, Bronze, Gold
- 150 kg capacity for all 32mm diameter calibre grab rails
- Mod 32mm diameter rails are approved for standard AS1428.1 requirements in DDA bathrooms
CONTENTS
- 2 x Wall Brackets
- 4 X Stainless Screws 12g × 50
- 2 x Grub Screws M6 × 5
- 1 x Grab Rail
- 1 x Toilet Roll Holder
INSTALLATION INSTRUCTIONS
-
Locate wall studs, and install into at least one stud. Place wall seal/mounting bracket on wall at correct height over centre of stud and mark hole positions on wall (minimum 2 supplied screws per bracket).
-
Drill pilot holes into wall stud approximately 50mm deep to suit mounting screws (and wall plugs if required).
-
Apply a small amount of silicon to the mounting bracket and wall in and around the screw holes.
-
Install mounting brackets by screwing onto wall
- Tip: use appropriate mounting screws for the wall stud material, supplied screws are for timber wall studs, one larger bugle screw can be used in centre hole.
-
Slide rail tube into end bracket and push onto wall brackets.
Tip: rail length can be cut down to a smaller size, simply use an angle grinder, hacksaw or pipe cutter then deburr the end with a file or grinder and reinsert into the end bracket. -
Tighten grub screws with the Allen key.
Tip: if rail rattles, loosen the end bracket, twist slightly and tighten.
WARNING:
These rails are designed to be mounted onto wall studs or masonry walls. Installation is recommended to be completed by a qualified tradesperson who complies with the AS 1428.1- 2009 Design for Access and Mobility standard. It is recommended rail location is determined by a qualified Occupational Therapist or trained professional to the AS 1428.1-2009 standard. Correct installation is required to ensure safe, long-term operation. Incorrect mounting can result in reduced capacity of the rail which can result in injury to user and damage to the wall.
- WWW.AVAIL.DESIGN
- INFO@AVAIL.DESIGN
- 1300 945 720
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>