SUNRICHER SB2868K12-5C 2.4G Wireless Remote Control Instruction Manual
- July 17, 2024
- SUNRICHER
Table of Contents
RGB+CCT Color RF+2.4G Remote
Important: Read All Instructions Prior to Installation
Function introduction
Product Data
| Protocol | 2.4G RF |
|---|---|
| Operation Voltage | 3VDC (CR2032 battery) |
| Transmission Frequency | 2.4GHz |
| Transmission Range (free field) | 30m |
| Dimming Range | 0.1%-100% |
| Dimension | 137x40x11.5mm |
| Waterproof Grade | IP20 |
- 2.4G mesh DIM, CCT, RGB 3 in 1 remote control
- Enables to control 4 zones of receivers
- Easy & quick pairing to the 2.4G mesh receivers by simply pushing the buttons
- Mesh network for further control distance, receivers can transmit signal to each other
- Each remote can control numerous receivers
- Each receiver can be paired to max. 8 remote controls
- The controlled receiver status can be quickly synchronized to the smart APP
- Transmission range between every two neighbor devices up to 30m
- 2.4G low power consumption technology, long battery life
- Enables to bind and control universal DIM, CCT, RGB, RGBW and RGB+CCT lighting devices
Safety & Warnings
- This device contains button lithium batteries that shall be stored and disposed properly.
- DO NOT expose the device to moisture.
Pair with 2.4G Mesh Receiver
Step 1: Do wiring the receiver according to wiring diagram (please refer
to the instruction of 2.4G mesh receiver that you would like to pair with.
Step 2: Click the prog. button once, or reset power of the controller 3
times continuously to set LED controller into pairing mode.
Step 3: Click a zone button to select a zone (e.g. zone 2).
Step 4: Click any other button except zone buttons (e.g. ),LED lights
connected with the receiver flicker once means the receiver is paired with
zone 2 successfully.
Set Sync for Multiple Receivers
If there are multiple receivers you want to set them keep sync status when in
running modes, you can configure after the following steps:
Step 1: Do wiring the receivers according to wiring diagram and select
one of them as master receiver.
Step 2: Click the “Prog. ” button
on the master receiver 2 times to set it as master receiver and enter pairing
to RF remote status.
Step 3: Click a zone button to select a zone 1/2/3/4 (e.g. zone 2).
Step 4: Then immediately click any other button except zone buttons (e.g.
), LED lights connected with the master receiver flicker once means the
receiver is paired with zone 2 as the master receiver successfully.
Step 5: Pair the other receivers into zone 2 by normal way.
Then you can click preset running mode button “ ” to play the color running
modes, the master receiver will send sync signal to all slave receivers, after
a short while, all receivers will be in sync mode.
Dimensions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>