EVOLVEO SHARK DVB-T Active Outdoor Antenna Instruction Manual
- June 17, 2024
- Evolveo
Table of Contents
EVOLVEO SHARK DVB-T Active Outdoor Antenna
Installation
-
A. Adjustment to the Mast
Place U-bolt through the mast, adjust the antenna bracket and fasten screws. -
B. Wall Mounting
Drill holes in the wall according to the holes position on the antenna bracket, hammer plastic anchors into the holes, attach bracket to the wall and secure with screws. -
Tie approx. 1 meter of the signal wire looses to the fixing pole at approx. 0.5 m below the antenna to allow the antenna to rotate. Install the antenna bracket to the railing using the U-bolt, adjust the rotation base to the bracket, clip the signal cable and fix the antenna onto the rotation base after adjusting to the right direction.
-
C. Railing Mounting (Balcony)
Install the antenna bracket to the railing using the U-bolt, adjust the rotation base to the bracket, clip the signal cable and fix the antenna onto the rotation base after adjusting to the right direction.
Fixing the Waterproof Cap
- Connect the signal cable to the signal output jack of the antenna and secure cable.
- Fix the waterproof cap covering the connections to avoid water filtration.
Connection and Usage
- Connect the signal cable from the antenna to the signal input jack of the power supply, connect the power supply output jack to the digital receiver, plug the power adaptor with the power supply and connect to power socket, and finally join the TV and the digital receiver.
- Connect the signal cable from the antenna to the signal input jack of the power supply, connect the power supply output jack to the TV, plug the power adaptor with the power supply and connect to power socket.
- Connect the signal cable from the antenna to the digital receiver, set the receiver to offer power to the antenna and join the TV and the digital receiver.
Adjustment on Receiving Directions
Disposal The symbol of crossed out container on the product, in the literature or on the wrapping means that in the European Union all the electric and electronic products, batteries and accumulators must be placed into the separate salvage after finishing their lifetime. Do not throw these products into the unsorted municipal waste.
DECLARATION OF CONFORMITY
Hereby, the company Abacus Electric, s.r.o. declares that EVOLVEO SHARK (EAN:
8594161330141) is in compliance with the requirements of the norms and
regulations, relevant for the given type of device. The complete text of
Declaration of Conformity can be found on ftp://ftp.evolveo.eu/ce
- Abacus Electric, s.r.o. Naxya Limited
- Copyright © 2020 Abacus Electric, s.r.o.
- All rights reserved. Design and specification can be changed without prior notice. www.evolveo.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>