SAL ESS107 Surface Socket User Guide

: July 14, 2024
: SAL

Table of Contents

SAL ESS107 Surface Socket
Product Information
Product Usage Instructions
Design Speciﬁcations
Technical Speciﬁcation
Dimensions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SAL ESS107 Surface Socket

Specifications

Model No.: ESS107
Input Voltage: 250V AC
Dimensions: 70mm (L) x 56mm (W) x 47mm (H)
Body Colour: White

Product Information

The ESS107 is a quick connect inline surface socket rated at 250V/10A. It is designed to save installation time and money.

Design Specifications

Australian approved three-pin 250V, 10A socket compliant to AS/NZS3112:2017
Secure clip lock design
Innovative transparent rear termination inspection cover
Durable polycarbonate construction
Designed to suit 1.0mm to 2.5mm flat twin and earth TPS, stranded, or solid conductors for installation by a qualified electrical installer
Colour: White

Technical Specification

Product Model No.: ESS107
Input Voltage (V/AC): 250
Dimensions (mm): 70(L) x 56(W) x 47(H)
Body Colour: White

Product Usage Instructions

Ensure the power source is switched off before installation.
Identify and connect the appropriate conductors to the socket terminals.
Securely clip lock the design in place.
Use the transparent rear termination inspection cover to ensure correct connections.
Verify that the socket is compatible with the conductor size being used.
If unsure, consult a qualified electrical installer for installation.

FAQ

Q: Isthe ESS107 suitable for outdoor use?
A: No, the ESS107 is designed for indoor use only.
Q:Can the ESS107 be used with stranded conductors?
A: Yes, the ESS107 is compatible with stranded conductors within the specified size range.

SURFACE SOCKET – QUICK CONNECT ESS107
Quick connect inline surface socket, 250V / 10A rated

Application

Inline surface socket designed to save you installation time and money

Design Speciﬁcations

Australian approved three pin 250V, 10A socket, compliant to AS/NZS3112:2017
Secure clip lock design
Innovative transparent rear termination inspection cover
Durable polycarbonate construction
Designed to suit 1.0mm to 2.5mm ﬂat twin and earth TPS, stranded or solid conductors for installation by a qualiﬁed electrical installer
Colour white

Technical Speciﬁcation

Due to continued product and technology enhancements, data sourced from sal.net.au shall not form part of any contract and or technical performance guarantee unless expressly conﬁrmed in writing by SAL at the time of order. Products are sold in accordance with SAL Terms and Conditions of sale and all images shown are for illustration purposes only and may vary from the actual colour or ﬁnish. Unless speciﬁcally stated, all IP ratings nominated for Interior products are from “below the ceiling”.

Dimensions

NSW/ACT: 02 9723 3099 QLD: 07 3879 5999
VIC/TAS/SA/NT: 03 9532 3168 WA: 08 9248 7458
www.sal.net.au
PDF Prepared: 31.1.2024 2:14pm Last page update: Nov 2023
© Copyright SAL – All Rights Reserved

DID YOU KNOW ?
In the interest of safety and product performance, all electrical accessory components are covered by mandatory Australian and International Safety Standards. Always look out for the RCM logo on the product and if in doubt, check the compliance via your local Electrical regulator.