AVIANCE lighting HD04191 22.5 Inch 3 Light Black Outdoor Hardwired Wall Lantern Instruction Manual

Table of Contents

Lantern

AVIANCE-lighting-HD04191-22-5-Inch-3--Black-Outdoor-Hardwired-Wall-Lantern-
product

Assembling the Fixture

Shut off the power at the circuit breaker and remove the old fixture.
Unpack the new fixture and lay out all parts in a clear area.
Attach the mounting screw partway into the side hole of the crook crossbar and secure it with a hex nut.
Attach the crossbar to the junction box using two box screws with the side marked GND facing out.
Follow wiring instructions carefully.
Hook the lamp body’s loop with the end of the arm and align the end hole.

Connecting the Wires

Connect the Black wire from the fixture to the black house (hot) wire.
Connect the White wire from the fixture to the white (neutral) house wire.
Secure all wire nuts and optionally wrap connections with\ electrical tape.
If your outlet box has a ground wire, connect the fixture’s ground wire to it; otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction box and test the fixture. Thank you for purchasing an AVIANCE product.

Q: What should I do if some parts are missing?

A: For assistance with parts or assembly, please email customer service at: info@aviancelighting.net

The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product

ASSEMBLING THE FIXTURE (Fig.1)

Shut off the power at the circuit breaker and remove old fixture, including the single bar. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
Attach the mounting screw part way into the side hole of the crook cross bar, then lock it securely with hex nut until becoming. Attach the cross bar to the junction box using two box screws. The side of the cross bar marked “GND” must face out.
Follow wiring instructions carefully (see fig.2).
Using the end of arm(A) hook the lamp body’s loop, align the end hole of arm(A) with the top hole of the back plate, lock it securely with screw(E) and\ hex nut.
Attach the back plate of the lamp body(B) onto the junction box, aligning screws on cross bar with mounting holes and lock it securely with the ball nuts(C).
Install the light bulbs(Not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
With silicone caulking compound, caulk completely around where back of cover meets with the wall surface to prevent water from seeping into junction box.

CONNECTING THE WIRES (Fig.2)

Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net