GERMAN TOU-716 Wall Mount Range Hood User Manual

GERMAN TOU-716 Wall Mount Range Hood

• Please read these user manuals and warranty information carefully before use and keep them handy for future reference.
• Please register your warranty information now ForWarrantyTerms & Conditions, please refer to the last page of the User Manual.

Notice Before Use

Important

• For safety purposes, you should read the instructions carefully before using the appliance for the first time. Save the instructions for future reference.
• The appliance is designed for domestic use and may only be installed and operated under these instructions for use.

1. The appliance is not intended for the use of, and playing with, by persons ( including children ) with reduced physical, sensory, or mental capabilities, or any individual lack of experience and knowledge unless they have been given supervision or instruction.
2. Keep children away from the appliance do not let them use the appliance without supervision.
3. If the power supply cord is damaged, do not operate the appliance. Contact German Pool or a licensed technician for a replacement immediately.
4. Disconnect the power supply before cleaning, repairing, or dismantling the range hood.
5. The range hood must be earthed.
6. Connect the range hood with a dependent air vent to the exhaust lamp black.
7. The air must not be discharged into a venting pipe that is used for exhausting fumes from appliances burning gas or other fuels.
8. The appliance should be positioned 700±50mm above the cooking range.
9. Do not flame under the range hood.
10. Please wear safety gloves for installation, cleaning, light bulb changing, and dismantling, to prevent injuries.
11. To protect electrical parts, do not splash or spray the range hood with water.
12. The German Pool range hood has high venting efficiency. Most of the grease vapor will be exhausted through the air vent when the range hood is in operation. Only a very small amount of residual oil will be collected in the Oil Collecting Tray.
13. There should be adequate ventilation in the room when the range hood is used along with appliances that burn gas or other fuels.
14. Regulations concerning the discharge of air have to be fulfilled.
15. To prevent fire hazards in case of oil build-up, the Turbine Impellers and other easily soiled parts must be cleaned at least once a week.

Product Structure

1. Switch
2. Light Bulb
3. Oil Collector (small) (1 pair)
4. Bottom Cover
5. Safety Mesh (1 pair)
6. Oil Collector (1 pair)

Installation Instructions

Pre-installation Notice

• The range hood must be installed and repaired by authorized qualified technicians.
• Before installation, plug in and check if all switches are functional.

Installation Environment

• For efficient air extraction, avoid opening too many windows surrounding the range hood. This will cause air convection, preventing cooking fumes from rising to 25 cm (the effective suction/exhaust area).

Height of Installation

• The appliance should be positioned 700 ± 50mm above the cooking range. A distance near 700mm results in higher venting efficiency (Fig A).

Length of Exhaust Pipe

• The length of the exhaust pipe should be minimized to avoid air turbulence inside the pipe (Fig B).

Keep the Hood Level

• The installation of the hood should remain level, to prevent oil from spilling over from oil collectors (Fig C).

Wiring Diagram

Operating Instructions

Important

1. The exhaust duct must be exposed outdoors.
2. There should be adequate ventilation in the room when a gas cooking range or other fuels are in use for cooking.
3. The air from the range hood must not be discharged into a venting pipe that is used for exhausting fumes from appliances burning gas or other fuels.
4. It is advised to keep the range hood running for 1 minute after cooking to completely expel the fumes from indoors and inside the machine.

Control

1. Fan Speed
   • Select   fan speed : Select fan speed with one of the Fan Speed buttons.
   • Fan off : To turn off the fan, just press the Motor ON/OFF switch to “OFF”.
2. Light Switch
   • Press the Light switch to turn it on.

Care & Maintenance

Important

• To ensure the most optimum efficiency, the range hood must be cleaned at least once a week.
• The power plug must be disconnected before cleaning and repair.
• Use mild detergent to clean the surface of the hood each time after use.
• Clear oil from oil collectors when they are more than half full of grease, to avoid spilling.
• Warning: There is a risk of fire if the repair and cleaning of the range hood (especially the fan and other easily soiled parts) are not carried out under the instructions.

Care & Maintenance Procedures

1. Switch off the power supply before cleaning the range hood.
2. Remove the two oil containers, then turn the 3 screws to detach the bottom cover.
3. Detach the oil-collecting trays by turning them clockwise.
4. Loosen the locking caps by turning the caps clockwise and taking out the turbine impeller.
5. Use a soft cloth to clean the inner and outer surfaces with a mild liquid detergent, and then rinse the trays with water. Avoid using a rough or metal brush to scrub the surface.
6. After cleaning, assemble the parts in reverse order as shown above. To ensure safety, make sure that the bottom cover is securely hooked to the hood body.

Troubleshooting

If you encounter the following common troubles, please solve them according to the following instructions. If the problem cannot be solved or a cause cannot be found, please contact our customer services center.
Note : For safety purposes, do not dismantle the product for repair by yourself.

inserted into the socket properly

–  The light is out of order

– The power cord comes off and is not attached properly

| – Check whether the plug is properly plugged into the socket

– Change the light bulb

– Repair or replace

The machine is not working.| –  Impeller gets stuck

– The capacitor is not well connected or damaged

–  Motor is damaged

| – Clear impeller from obstructions

– Repair or replace

– Repair or replace

The hood vibrates.| –  Not firmly mounted

–  Not installed securely

–  Impeller is damaged and becomes imbalanced

| – Secure the hood

– Secure the hood

– Repair or replace

The fan works at one speed but not at another.| –  Power switch malfunction

–  Circuit is not connected well

| – Repair or replace

– Repair or replace

Does not exhaust effectively.| – The hood is mounted at a rather high position| – Lower the installation position

Technical Specifications

(W) 708 mm

(D) 508 mm

Net Weight| 10.3 kg

• Specifications are subject to change without prior notice.
• If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail www.germanpool.com.
• Refer to www.germanpool.com for the most up-to-date version of the User Manual.
• Please fill out the form below. This information and the original purchase invoice will be required for any repairs.
• The warranty will be invalid if the information provided is found to be inaccurate or the purchase invoice is not presented.
• Model No: TOU-716
• Serial No:- ——————————–
• Invoice No:———————————-
• Purchased From:- —————————–
• Purchase Date:————————————

Warranty

Warranty Terms & Conditions

• Under normal operations, the range hood will receive a 1-year full warranty and the motor therein a 3-year warranty provided by German Pool (effective starting from the date of purchase).
• This warranty is not valid until the Customer’s registration information is returned to and received by our Service Centre within 10 days of purchase via one of the following methods:

1. Visit our website and register online: www.germanpool.com/warranty
2. Complete all fields on the attached Warranty

Card and mail it back to our Customer Service

Centre along with a photocopy of the purchase invoice (Warranty Card and invoice copy will not be returned to Customer)

1. Customer who fails to present the original purchase invoice will be disqualified for free warranty.
2. Customers should always follow the operating instructions. This warranty does not apply to:
   • labor costs for installation, on-site check-up, replacement of parts, and other transportation costs;
   • damages caused by accidents of any kind (including transport and others);
   • the casing of the hood body, light bulbs, plastic parts, and accessories such as oil collecting cups;
   • operating failures resulted from incorrect voltage, improper operations, and unauthorized installations or repairs.
3. This warranty is invalid if:
   • the purchase invoice is modified by an unauthorized party;
   • product is used for any commercial or industrial applications;
   • product is repaired or modified by unauthorized personnel, or unauthorized parts are installed;
   • serial number is modified, damaged, or removed from the product.
4. German Pool will, at its discretion, repair or replace any defective part.
5. This warranty will be void if there is any transfer of ownership from the original purchaser.
   • Service area includes Hong Kong Island, Kowloon, and New
   • Territories only. Repairs in Tung Chung, Discovery Bay, or other areas are subject to an extra service charge.

Customer Service & Repair Centre

• German Pool (Hong Kong) Limited
• 8/F, China Travel (Cargo) Logistics Centre
• 1 Cheong Tung Road
• Hung Hom, Kowloon, Hong Kong
• +852 2333 6249
• +852 2356 9798
• repairs@germanpool.com

German Pool (Hong Kong) Limited

• Hong Kong, China
• Room 113, Newport Centre Phase II,
• 116 Ma Tau Kok Road, Tokwawan,
• Kowloon, Hong Kong
• Eas Tel: +852 2773 2888
• 19 A Fax: +852 2765 8215
• All rights reserved. Copying, reproducing, or using the contents of this manual is not allowed without prior authorization from German Pool, violators will be prosecuted
• www.germanpool.com

Documents / Resources

| GERMAN TOU-716 Wall Mount Range Hood [pdf] User Manual
TOU-716 Wall Mount Range Hood, TOU-716, Wall Mount Range Hood, Mount Range Hood, Range Hood, Hood
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>