GERMAN POOL SCC-WL60 Cordless Upholstery Fabric Cleaner User Manual

GERMAN POOL SCC-WL60 Cordless Upholstery Fabric Cleaner

Please read these instructions and warranty information carefully before use and keep them handy for future reference.

Online Warranty Registration

Warnings & Safety Precautions

WARNING!
Read all instructions carefully before using this product.

• This product is for domestic indoor use only. If this product is used for any commercial, industrial, rental or other purposes, product warranty will be VOIDED.
• This product is not intended for use by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of this product by an adult responsible for their safety.
• Mind your children and DO NOT let children play with this product.
• Cleaning and user maintenance shall not be made by children without supervision.
• Check the voltage indicated on the rating label before using this product.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazards.
• Unplug this product from the power source before cleaning and maintenance.
• Contact German Pool authorized service technician for repair or maintenance of this product.

1. Only authorized technicians can disassemble this product. It is strictly prohibited to disassemble this product by themselves.
2. This product can only use the original type-C charging line. If other charging lines are used, the product may be damaged.
3. DO NOT roll the curtain, all kinds of winding materials or user’s body parts into the product roller brush.
4. DO NOT put this product near cigarette butts, lighters or other open flames.
5. If the product needs cleaning, please clean the product after charging.
6. DO NOT put heavy objects and sharp objects on the machine.
7. This product is an indoor household product. DO NOT use it outdoors.
8. It is forbidden to press articles (people) above 10 kg. DO NOT place anything weighing 10 kg or above on top of this product.
9. Before using this product, please remove all vulnerable items on the ground (such as glasses, lamps) and items that may entangle the floor brush and air suction channel (such as wires, paper, curtains).
10. DO NOT put this product in a place that is easy to fall (such as tables and chairs).
11. During transportation or when the product will not be used for a long time, please pack it before storing.
12. Please carefully check whether the charging cable is connected before charging.
13. When the waste water in the tank with waste water is full, please empty it before using this product.
14. The ambient temperature of this product is 5°C to 40°C.
15. DO NOT use this product in high temperature environment.
16. Please remove the battery from the product before scrapping this product.
17. It is strictly prohibited to modify the whole machine, accessories and replace the power supply or battery.
18. DO NOT place this product on its side or upside down.
19. Recycling of batteries: Waste batteries are an important resource. When discarding products, DO NOT discard batteries at will. Please properly dispose of them in accordance with government regulations and assist in recycling them to corresponding waste battery recycling facilities.

Product Structure

Main Body

1. Flexible Hose & Handheld Nozzle
2. LED Display
3. Control Buttons
4. Main Unit
5. Clean Water Tank
6. Charging Port
7. Air Outlet Grille
8. Dirty Water Tank
9. Suction Inlet
10. Sprinkler Head
11. USB-C Cable

Note:
It is recommended to use the Flexible Hose & Handheld Nozzle when cleaning vertical surfaces (eg. sides of sofa).

Operation Instruction

Control Panel

How To Charge

Note:

• The battery is not charged when this product left the factory. Please make sure the battery is fully charged before use.
• This product must be turned off during charging.

1. Place this product on a horizontal and sturdy surface. Connect the type-C cable to the charging port on the main body, and the other end into an USB charger (it is recommended to use 5V) to charge this product.
2. LED display will show current battery %, and the Charging Indicator Light will blink. The charging time is approx. 4.5 hours, and the working time is approx. 30 minutes.
3. When the product is fully charged, Battery Power % will show 100%, and Charging Indicator Light will light up constant.

Note:

• DO NOT charge, use or keep this product in an environment below 5°C or above 40°C.
• When product is in use, LED display will show the Battery Power %. When Battery Power % falls below 10%, charge the battery immediately.
• The battery is a consumable. After prolonged use, product will take longer to charge and battery will not last as long. This is a normal phenomenon.

Filling The Clean Water Tank

1. Clean Water Tank is located at the back end of the main unit. Please fill up prior to first use, or whenever the tank is empty.
2. To take out the tank: Hold the tank firmly and pull out.
3. Open the tank lid and fill tank with water.
4. Reattach the water tank properly back onto the main unit.
   

Note:

• To avoid blocking the air duct, large pieces of garbage (eg. large pieces of paper, wrapping film, etc.) in the area must be removed before using this product.
• This product is not a vacuum cleaner; it can only be used to suck up liquid, and thus must be used together with the sprinkler. DO NOT dry vacuum.
• When this product is in operation, DO NOT touch the bristles on the roller brush, and DO NOT block the air outlet grilles on the sides of the main unit.
• Press On/Off Button to turn on the product. LED display shows Battery Power %, and product starts to operate.
• Long-press Spray Button and the sprinkler will spray water continuously; when user lets go of the button, spraying will stop.
• Press Roller Brush Button and the roller brush will start spinning, Roller Brush Indicator Light on the LED display will light up constant; press Roller Brush Button again, roller brush will stop spinning and the corresponding indicator light will turn off.
• When product is in use, the Battery Power % will drop continuously. Please recharge when it drops too low.

How To Use

1. When product is turned on, long-press Spray Button to wet the surface of the cleaning area.
2. Press the nozzle flat against the surface to be cleaned, and push the product forwards to suck up the fifth. To clean a large surface area, long-press Spray Button ****while simultaneously pushing the product forwards.
3. For stubborn stains, press Roller Brush Button to turn on the roller brush, and run the product back and forth over the stain to lift out the fifth.

Using The Flexible Hose & Handheld Nozzle

1. Press the release button located on the bottom of the Suction Inlet Cover and pull off the cover.
2. Attach the Flexible Hose & Handheld Nozzle onto the Suction Inlet on main unit. The Flexible Hose Indicator Light lights up constant.

Note:
The roller brush will not spin when Flexible Hose & Handheld Nozzle is attached, and pressing Roller Brush Button will not yield any response.

Cleaning and Maintenance

WARNING!

• Turn off this product and let it cool down completely before cleaning and maintenance.
• DO NOT immerse this product or its power cord in water or any liquid. Cleaning The Dirty Water Tank.

Cleaning The Dirty Water Tank

Note:
Make sure to clean out the Dirty Water Tank in time. DO NOT allow dirty water to accumulate beyond the maximum water mark on the Dirty Water Tank.

1. To maintain product performance, please clean the Dirty Water Tank regularly. It is recommended to clean the tank every time after use.
2. To take out the tank: The Dirty Water Tank is located on the bottom of the main unit, press and hold the Dirty Water Tank Release Buckle, and pull the tank downwards to detach it.
3. Clean out the dirty water and debris, and rinse the tank clean.
4. Reattach the tank back onto the main unit.
   

Cleaning The Roller Brush

1. To ensure the roller brush can operate smoothly, remove debris immediately when the brush bristles are dirty or entangled.
2. Take off the Suction Inlet Cover, push the Roller Brush Buckle inwards and pull out the roller brush, then rinse the bristles clean (only the roller brush bristles can be rinsed with water; DO NOT wet the other parts).
3. Reattach the roller brush correctly back onto the main unit.

Note:

• Remove any blockage or entanglement promptly.
• Only the roller brush bristles can be rinsed with water; DO NOT wet the other parts.
• DO NOT apply lubricant to the two ends of the roller brush.
• DO NOT use this product if the roller brush bristles are damaged.

Troubleshooting

sprinkler head with a small pin
Clean water tank is empty| Refill clean water tank
The water pipe is blocked| Contact German Pool Customer Service & Repair Centre
Motor emits abnormal noise| Suction inlet is blocked or product has sucked in large debris| Remove blockage
Dirty water tank is not installed properly| Inspect and install dirty water tank properly
Product usage time has shortened| Battery has aged| Contact German Pool Customer Service & Repair Centre
Ambient temperature too high or too low| Use this product in a suitable environment (5°C-40°C)
Battery is not fully charged| Fully charge battery before use
Suction power has weakened| Too much water in dirty water tank| Clean out dirty water tank
Suction inlet is blocked| Remove blockage
Product will not charge| Ambient temperature is too high or too low| Charge this product in a suitable environment (5°C-40°C)
Battery leakage| Battery has not been used in a long time| Contact German Pool Customer Service & Repair Centre

WARNING
If problem persists, please contact German Pool Customer Service & Repair Centre for inspection and repair. DO NOT disassemble product by yourself.

Technical Specification

• Specification is subject to change without prior notice.
• If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail.
• Refer to www.germanpool.com for the most update version of the user manual.

Warranty Terms & Conditions

Under normal operations, the product will gurantee a 1-year full warranty provided by German Pool (effective from the date of purchase).

• This warranty is not valid until customer registration information is received by our Service Centre within 10 days of purchase via one of the following means:

  1. Visit our VIP App and register online: (Scan the QR Code on the left)
  2. Visit our website and register online: www.germanpool.com/warranty
  3. Complete the attached Warranty Card and mail it back to our (Scan the QR Code on the left) Customer Service Centre.
     

Customer Service & Repair Centre

Hong Kong

Unit B, G/F, Sunshine Kowloon Bay
Cargo Centre, 59 Tai Yip Street, Kowloon Kowloon, Hong Kong
Tel : +852 2333 6249
Fax : +852 2356 9798
Email : repairs@germanpool.com

Macau

A, 1 Andar, Mei Kui Kuong Cheong Fase 2,
No.515 Avenida Do Conselheiro Borja Macau
Tel : +853 2875 2699
Fax : +853 2875 2661

This warranty is valid only in Hong Kong and Macau

German Pool (Hong Kong) Limited

Hong Kong
Room 113. Newport Centre Phase II. 116 Ma Tau  Kok Road. Tokwawan. Kowloon. Hong Kong.
Tel: +852 2773 2888
Fax: +852 2765 8215

China
Tel:+86 757 2219 6888
Fax:+86  757 2219 6809
8th, Xinxiang Road, Wusha Industrial Park, Daliang, Shunde, Foshan, Guangdong

Macau
A, 1 Andar, Mei Kui Kuong Cheong Fase 2, No.515 Avenida Do Conselheiro Borja, Macau
Tel: +853 2875 2699
Fax: +853 2875 2661

www.germanpool.com

References

• 德國寶German Pool | 家庭電器、廚櫃、傢俬 | 香港十大名牌
• German Pool

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>