MEDLINE MDS86410SGB Stand and Go Walker User Manual

MEDLINE MDS86410SGB Stand and Go Walker User Manual

MDS86410SGB

**What’s Included:

**

• A: 2 Front legs with wheels
• B: 2 Back legs without wheels
• C: Walker frame
• D: 2 Handles with handgrips
• E: 2 Triangular knobs

This guide applies to the following rollator:

Safety Instructions

For Safety, these precautions must be taken when using this products.
Before Each Use make sure:

• Walker is adjusted to the correct height.
• Locking mechanisms and spring buttons are fully engaged.
• Wheels are in good condition.
• Make sure the walker sits level.

Always Use extreme care when using a walker. Avoid all potential safety hazards including slippery, uneven or soft surfaces and objects in path.

DO NOT use on stairs. The use of walkers in water (showers, bathtubs, pools etc) may corrode the working mechanisms of your walker. The use of a corroded walker may result in damage to the walker and/or injuries to the user.

DO NOT exceed the maximum weight capacity of your walker.

DO NOT use your walker if you have any handicaps or disabilities or using medications etc that would impair of interfere with safe usage of this product. Failure to follow the above instructions may result in serious injury.

Assembly Instructions

First: Open the Walker Seat Assembly

Remove the walker components from shipping carton. Then, in an upright position unfold the walker frame and place on its side.

IMPORTANT NOTE:
Proceed with caution when assembling as there are areas around the moving parts that could potentially pinch fingers.

Now: Install the Legs

1. Insert one front leg with wheel into the base of the walker. Ensure the push button is engaged. Wheel should always be on the outside of the walker frame.
   

2. Repeat with the other front leg and make sure the push button is engaged.

3. Insert the back leg (without wheel) into the frame of the walker.
   

4. Repeat with the other back leg. Ensure both legs are locked in place before use.

Finally: Install Handles

1. Insert one handle into the base of the walker frame.
2. Slide up or down to adjust to your height preference, then insert the 3 point knob into the walker and tighten.
3. Repeat with the other handle.
   Ensure both hand rests/grips are tightened before use.
   

How to Use

How to Use From Sitting Position

1. Push locking button until lock shows red. Gently press down to lower the handles into place.
   

2. Pull the unit around the body & use the hand grips & balls to help you stand straight up.
   

3. Lift up on the handles lightly. The walker handles will rise to walking height. Make sure the locks show green to indicate they are locked into walking position.
   

Support

Not made with Natural Rubber Latex.
Medline Industries, Inc.
Three Lakes Drive, Northfield, IL 60093 USA
1-800-MEDLINE (633-5463)
medline.com | info@medline.com

Some products may not be available for sale in Mexico or Canada. We reserve the right to correct any errors that may occur within this brochure.
© 2019 Medline Industries, Inc. All rights reserved. Medline is a registered trademark of Medline Industries, Inc.

MDS86410SGB (Rev: 03-07-19)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>