BATH SAFETY

Do not install this product without first reading and understanding this instruction manual.

Failure to follow instructions may result in serious injuries.

FOLDABLE TOILET SAFETY FRAME

USER INSTRUCTIONS AND WARRANTY

Not made with Natural Rubber Latex.

LIFE TIME LIMITED WARRANTY

Your Medline brand product is warranted to be free of defects in materials and workmanship for the duration of use by the original purchaser. This device was built to precise standards and carefully inspected prior to shipment. This limited
warranty is an expression of our confidence in the materials and workmanship of our products and assures years of convenient, dependable service. In the event of a defect covered by this warranty, we will, at our option, repair or replace the device.

This warranty does not cover device failure due to owner misuse or negligence, or normal wear and tear. The warranty does not extend to non-durable components, such as rubber accessories, which are subject to normal wear and replacement. Non-durable components are warranted for 6 months. If you have a question about your Medline product or this warranty, please call us at 1-800-MEDLINE. This warranty gives you specific legal rights, and you may have other rights, which vary from state to state.

www.medline.com

©2018 Medline Industries, Inc. All rights reserved Medline is a registered trademark of Medline Industries, Inc.

Three Lakes Drive,

Northfield,

IL 60093 USA.

1-800-MEDLINE

IMPORTANT SAFEGUARDS

Read all instructions before using. Important information is highlighted by these terms:

WARNING – Important safety information for hazards that might cause serious injury.

CAUTION – Information for preventing damage to the product.

NOTE – Information to which you should pay special attention.

READ ALL INSTRUCTIONS BEFORE USING.

WARNINGS:

Please read carefully before use. Failure to comply may result in severe injury.

DO NOT exceed the 250 lbs (113 kg) maximum weight capacity of this safety frame.

Evenly distribute weight between the armrests during use.

Ensure all detent buttons are properly engaged in position prior to use.

FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN SERIOUS INJURIES.

SAVE THESE INSTRUCTIONS.

ASSEMBLY INSTRUCTIONS

Before beginning assembly, identify all parts (Figure 1)

1. Remove existing toilet seat assembly, including bolts and nuts.

2. Place toilet safety frame bracket between toilet fixture and seat assembly
   with rounded part of bracket closest to the back of toilet (Figure 2).

3. Replace toilet seat assembly and reinsert the original mounting bolts through
   front holes of the bracket and toilet fixture (Figure 3). Tighten the nuts.

4. Depress the built-in snap buttons and tighten the locking collar on each side
   of the safety frame (Figure 4).

5. Slide each side frame into desired width position. Insert black adjustments
   hand knobs to the bracket and tighten to secure into place (Figure 5).

6. Adjust foot pieces to desired height (Figure 6). Make sure both foot pieces are
   fully engaged and adjusted at equal heights.

7. Make sure mounting hardware is tightened and all snap buttons are fully
   secure before use.

Product fully assembled

CLEANING

Your safety frame can be easily cleaned with regular household cleaning
products. DO NOT use abrasive powders or scouring pads.

Grip cleaning instructions

Clean the grips with a mild soap, detergent or household cleaner. DO NOT use an
organic solvent (such as acetone, MEK, lacquer thinner, lighter fluid, dry cleaning
fluid, gasoline or turpentine) that may dissolve the plastic and cause the grip
to loosen.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>