Lights Flush Fitting Light Instructions
- June 7, 2024
- Lights
Table of Contents
Flush Fitting Light Installation Instructions
Only qualified persons should assemble the luminaire. If in doubt, consult a
suitably qualified person.
Installation MUST be carried out in accordance and compliance with current
building regulations.
All Tom Raffield Flush Fitting shades have been designed to fit the E27/ES (Edison Screw) fitting ceiling/ wall kit provided. Connect the lamp holder (A) to the electricity supply (220-240V AC 50-60Hz). This must be installed by a qualified electrician before following the instructions below.
Ensure the electrical supply is turned OFF at the fuse board.
- To fit the lampshade to the flush ceiling/wall kit, unscrew the first shade ring (A) exposing the thread of the lamp holder. Sandwich the wooden disk (B) of the lampshade between both shade rings and tighten to ensure the shade is held securely.
- Screw-in your chosen light bulb. The lampshade has been designed to work with an LED bulb, up to a maximum of 25 Watts.
- Turn the power supply on to complete installation.
For more information on the installation of your product:
contact@tomraffield.com
+44 (0)1326 722725
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>