Garden Lights 4138603 Lunia Set Smart Outdoor Lighting Instruction Manual
- October 30, 2023
- GARDEN LIGHTS
Table of Contents
Garden Lights 4138603 Lunia Set Smart Outdoor Lighting
Product Information
The LUNIA SET (Article No.: 4138603) is a set of 3 garden lights by Techmar. Each light is 12 volt and has a power of 1 Watt. The lights have a color temperature of 3.000 / 6.000 Kelvin and a brightness of 90 Lumen. They have a lifespan of 25,000 hours and are non-dimmable. The power factor is greater than 0.5 and the failure rate is less than 5% after 1000 hours and less than 10% after 6000 hours. The flux is greater than 80% after 6000 hours and the CRI is greater than 65. The LED lights are AC/DC 12V and non-replaceable. The set comes with an IP44 housing and an input voltage of 100-240VAC 50/60Hz with an output of 12V DC Max: 12W. The set includes a skewer for use in solid soil and an SPT-1W 18AWG cable of length 8m.
Product Usage Instructions
- Scan the QR code provided in the manual for more information about the product.
- Sort the packaging and product separately for recycling.
- To set the desired light color, set the switch to the desired position.
- For use in solid soil, insert the skewer into the ground.
- For use on surfaces such as stone or wood, attach the plug to the surface with at least 2 screws and turn the lamp clockwise.
- If you have any questions regarding parts, service, complaints, or any other matter, contact Techmar at [email protected].
- Do not discard the product in household waste. Take it to a recycling company for proper disposal.
- The product meets the EU standards for health, safety, and environmental protection.
- The product meets the safety requirements specified in the regulations of the EAEU.
- For more information about recycling, contact a municipal waste processing company or your dealer.
Specification
- 1 Watt
- 3.000 / 6.000 Kelvin
- 90 Lumen
- 25.000 Hours
- On/Off 10.000
- Non-Dimmable
- Instant full light
- Power factor > 0,5
- Failure < 5% after 1000h
- Failure < 10% after 6000h
- Flux > 80% after 6000h
- CRI > 65
- Non Replaceable
Package Content
Symbols
Assembly
- Gebruik van de spies in vaste grond.
- Using the skewer in solid soil.
- Verwenden Sie den Spieß in festem Boden.
- Utilisation de la brochette dans un sol solide.
Use of the skewer on, for example, stone or wood. Attach the plug to the surface with at least 2 screws. Turn lamp clockwise.
For questions about parts, service, any complaints or other matters, you can
contact us at any time.
E-mail: [email protected].
- The packaging and product must be sorted separately for recycling
- This product meets the EU standards for health, safety and environmental protection.
- Discarded electrical equipment must not be put in the household waste. If possible, take it to a recycling company. For details of recycling, contact a municipal waste processing company or your dealer.
- This product answers to the safety requirements specified in the regulations of the EAEU.
INSTALLATION OF THE LIGHTS
- Install the products in the desired position and lay the cables so they can be comfortably connected to the transformer or main cable.
- If products are provided with a drain hole for water, this hole must be pointing downwards.
- Use non-corrosive fixing materials (supplied as standard) if you want to bolt the products down.
- Connect the lights to the main cable by using the connector as shown in figure on page 5.
- Consult the manual of your transformer for more information.
SAFETY
- This is a general manual. Consult the product sheet for a detailed description per product.
- This transformer functions best at temperatures between -30 and 40 °C.
- The total wattage of the connected products may not exceed the power of the transformer, otherwise irreparable damage could occur to the transformer.
- The transformer must be connected to the regular power network (AC 230V 50/60Hz) and is suitable for use indoors as well as outdoors. Allowed for outdoor use only if connected to a moisture protected power outlet.
- Do not mount the transformer near a water-spraying system.
- If the fixed power cord (230 Volts 50 Hz) of the transformer is damaged, the transformer must be destroyed.
- The product may not be adjusted or converted, as this may make the product unsafe. The transformer may never be opened for the purpose of repair.
- Uses other than those for which the product was designed, may lead to damage and the risk of short circuit, fire or electric shock.
- The transformer’s plug may only be inserted into the socket once the entire lighting system has been installed.
- This is a double-insulated device and does not need to be connected to an earth conductor (Protection class II).
QR SCAN
Scan QR code for explanation
TECHMAR B.V. | CHOPINSTRAAT 10 | 7557 EH HENGELO | THE NETHERLANDS