Go Power GP-PWM-30-FM-DL 30AMP Solar Controller User Guide

Go Power GP-PWM-30-FM-DL 30AMP Solar Controller

OVERVIEW

GENERAL INFORMATION

The SOLAR CONTROLLER is suitable for use with lead acid batteries (vented, GEL, or AGM type) as well as some lithium iron phosphate (LiFePO4) batteries that are supplied with a Battery Management System (BMS). If using lithium ion, it must be lithium iron phosphate (LiFePO4) chemistry with a BMS. No other chemistries are compatible. Lithium batteries typically have maximum allowed charge currents. These maximums typically decrease in cold temperatures. The solar controller does not limit current for these restrictions, and system design of the solar array must account for this.

• Be sure to follow all battery manufacturer safety instructions.
• The controller will not work unless there is a battery connected to the Battery terminals

DISPLAY SYMBOLS

OPERATING INSTRUCTIONS

1. Cycle through the following display parameters by pressing the set and menu buttons.
   Display : PV voltage, PV current, PV power, Battery voltage and Battery temperature

2. Clear the generated energy

3. Step 1: Press the B button and hold for 5 seconds under the PV power interface and the value is flashing.

4. Step 2: Press the B button to clear the generated energy.

5. Switch the battery temperature unit
   Press the B button and hold 5s under the battery temperature interface.

6. Battery type 1 Sealed Gel Flooded

7. Set battery type by LCD.

Operation

1. Step 1: Press the “B” button and hold 5s under the battery voltage interface.
2. Step 2: Press the “A” button when the battery type interface is flashing.
3. Step 3: Press the “B” button to confirm the battery type.

Please use the LF1 profile for 12V applications and LF2 for 24V applications.

MOUNTING INSTRUCTIONS

Please note that the controller must be installed in a place with sufficient air flow through with a minimum clearance of 150 mm from the upper and lower edges.

1. Use the cutting template located in the full manual at gpelectric.com
2. Drill the holes in each corner based on the manual template
3. Nest the backplate in the hole in the wall
4. Secure the controller using the screw holes in the corners
5. Reattach the controller faceplate

For complete installation instructions use the complete manual at gpelectric.com

WARNINGS

Documents / Resources

| Go Power GP-PWM-30-FM-DL 30AMP Solar Controller [pdf] User Guide
GP-PWM-30-FM-DL 30AMP Solar Controller, GP-PWM-30-FM-DL, GP-PWM-30-FM-DL Solar Controller, 30AMP Solar Controller, Solar Controller, 30AMP Controller, Controller
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>