WALI MF002S Articulating Monitor Desk Stand Instruction Manual
- June 7, 2024
- WALI
Table of Contents
INSTALLATION MANUAL
Articulating Monitor Desk Stand
WARNING!
If you do not understand these directions, or if you have any doubts about the
safety of the installation, please call a qualified technician. Check
carefully to make sure there are no missing or defective parts. Improper
installation may cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual. Do not exceed
weight capacity. We cannot be liable for damage or injury caused by improper
mounting, incorrect assembly, or inappropriate use.
TIP-OVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT
TIPOVER:
- NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF THE MONITOR OR STAND.
- USE TIP-OVER RESTRAINT OR ANCHOR STAND TO WALL.
THE USE OF TIP-OVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE THE RISK OF
TIP-OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Supplied Parts List
NOTE: SOME HARDWARE INCLUDED MAY NOT BE USED
Step 1
Place Pole A onto the top center hole of Base B , connect Pole A
and Base B from the bottom using Bolt F and tighten with Allen Key 4mm
H.
Step 2
Put Arm C through Pole A , adjust the preferred height and tighten
using Allen Key 6mm I.
Step 3
Press Pole Cover G into the top hole of Pole A.
Step 4
Step 4.1
Step 4.2a
Select M4x12 Bolt M-A or M5x12 Bolt M-C according to your TV/Monitor,
connect VESA Plate D together with D5 Washer M-E into the mounting
holes on the back of TV/Monitor, tighten with a screwdriver.
(Screwdriver needed but not included)
Step 4.2b
Select M4x16 Bolt M-B or M5x16 Bolt M-D according to your TV/Monitor,
connect VESA Plate D together with D5 Washer M-E, and Spacer M-F
into the mounting holes on the back of TV/Monitor, tighten with a
screwdriver.(Screwdriver needed but not included)
Step 5
Put the assembled TV/Monitor onto the Arm C and ensure stability, connect
the VESA Plate D using Bolt E and tighten it by hand.
Step 6
Tighten/Loosen the side bolt of Arm C with Allen Key 6mm I, store Allen
Keys in the Cable Management Clip Holder, guide the cable through the Cable
Management Clip Holder.
Step 7
Manually swivel, tilt or rotate the angle for the best operating environment.
Thank you for choosing us!
We support the technology that brings your home to life.
We offer high-quality products, professional customer service, and extensive
technical support.
If you have any questions, please contact us.
1-844-SATTLER (18447288537)
support@walielectric.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>