oceanic NDK20-21A Electric Heater User Manual

: October 27, 2023
: Oceanic

Table of Contents

oceanic NDK20-21A Electric Heater
SAFETY WARNINGS
SAFETY PRECAUTIONS
DESCRIPTION
SUPPORT INSTALLATION
OPERATING INSTRUCTION
CARE AND CLEANING
WARRANTY TERMS
REPAIR SERVICES
TECHNICAL SPECIFICATION
CORRECT DISPOSAL OF THIS PRODUCT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

oceanic NDK20-21A Electric Heater

oceanic-NDK20-21A-Electric-Heater-
product

SAFETY WARNINGS

Please read this manual carefully before use and keep it for future use.

Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appli-ance or perform user maintenance.
CAUTION Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Disconnect from mains when not in use or cleaning.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
It is not recommended to use an extension cord.
The heater is hot when in use. To avoid burns, do not let bare skin touch hot surface.
Do not immerse cord, plug or any part of the appliance in water or any other liquid.
Warning: in order to avoid overheating, do not cover the heater.
WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material a minimum distance of 1 m from the air outlet.
The heater must not be located immediately below a socket-outlet.
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
Do not use this heater if it has been dropped or if there are visible signs of damage to the heater.
Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
Do not use outdoors.
Do not use the appliance for other than its intended use.
This appliance is intended for household use only.
Do not misuse the cord or pull the cable to disconnect it from the outlet. Instead, grasp the plug and pull it to disconnect.
Do not attempt to repair, disassemble or modify the appliance. There are no user-serviceable parts inside.
Do not insert or allow foreign objects to enter the ventilation or ex-haust openings as this may cause an electric shock, fire or damage to the appliance.
When the heater is turned on for the first time, it may release a slight, harmless odor. This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again.
In order to avoid any accident, please turn off the unit when people leave.
If do not use the product for a long time, please disconnect the plug, put the product into the box and stock the product in a dry and ven-tilated place.
When using the product, please do not locate the air outlet and inlet next to the wall or curtain to avoid obstructing the air and influence the effect.
Please do not let the power cord touching the front net cover in order to avoid the high temperature damaging the power cord.
Do not hang the wet clothes above the heater.
The voltage and frequency of the power supply must comply with the technical specification of the heater.
Clean the surface of the unit with damp cloth (or add some deter-gent). Do not use corrosive detergent or solvent to clean. Not allowed to wash directly with water.
Do not handle the power cord and plug by wet hands.
Do not insert the wood or metal stick or other slim objects into air inlet or outlet.
Regarding the instructions for the installation, thanks to refer to the below paragraph of the manual.
WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.

SAFETY PRECAUTIONS

Do not insert and pull out the plug with wet hand, as this may cause electrical shock, power supply capacity should be enough.
Do not allow smashing the surface with rod or sharp hard tools, as this may cause deform and get rusty because of damage of paint coat.
Unit surface temperature of the flanges is high, thus do not touch it except handle, knobs.
Don’t heat wet clothing etc. on the surface of the control chamber, as this may cause undue move of the thermostat.

WARNING

The surface temperature of the flanges is high, during use, thus closely supervise any children in the area of this appliance.
If malfunctions happen during operation please put it to nearby appointed service center with the maintenance card. Never disassemble it by yourself.
Be sure to pull out the plug from an outlet when not in use and before cleaning.
Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.

DESCRIPTION

oceanic-NDK20-21A-Electric-Heater-
fig-1

SUPPORT INSTALLATION

According to fig.1, turn the body down with the bottom upward, and the screw out onboard screws.
According to fig.2, remove the supports. Aim the buckle on the support at the hole, push the supporting foot until the holes on support coincides with the screw hole on the machine.
Penetrate the removed screws through the support holes and tighten in the machine table.
After the installation is completed, turn the body upward for use.

OPERATING INSTRUCTION

Check before turning on the machine

Check if the power wire is under good condition.
The product adopts 220-240V~ 50Hz power supply, before use, please confirm if the rated current of the power socket meets the local requirements, otherwise, please replace it with the qualified socket.
- Put the machine on the flat surface
  Please put the heater on the flat place, at least the surface below the base of the heater must be flat.
- Temperature Control Knob
  Insert the plug into the power socket, then turn the Temperature Control knob clockwise, when hearing the “poop” sound (it means the temperature controller is on), adjust the Temperature Control knob to the desired temperature level.
- Power Selection Knob
  Turn the Power selection knob to select between 4 functions: 0 (Off), I 800W (Low), II 1200W (Medium), III 2000W (High)
- Turn off the Heater
- Turn the Power selection knob to O position.
- Turn the Temperature Control knob anticlockwise to the initial position.
- Remove the power plug, store the heater after the entire machine has become cool.

Safety Protection

Overheat protection: This heater includes an Overheat Protection System that shuts the unit off if it overheats due to abnormal conditions. If this occurs turn the heater “OFF”, unplug it, and inspect and remove any objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it back in, and resume normal operation.
Inversion protection: When the whole heater is inverted, the safety system will automatically cut off the power, and return to the work state before inversion after the body is placed upright.

CARE AND CLEANING

ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING.

Turn the heater to “O” position, unplug it and wait for the heater to cool down.
Use a dry cloth to clean only the external surfaces of the heater.
Do not use any cleaning agents or detergents.
Never immerse the heater in water.
Pack the heater in the original carton and store it in a cool and dry place.
Avoid bruising or scratching products to avoid surface coating damage and rust.

WARRANTY TERMS

Your device is guaranteed by the manufacturer for a period of 24 months from the date of purchase (Use the dated invoice as proof).

EXCLUSIONS:
The warranty does not cover worn parts of the product, or problems or damage resulting from:

surface damage due to normal product wear
defects or deterioration due to contact of the product with food or liquids and due to corrosion caused by rust
any incident, abuse, misuse, unauthorized modification, disassembly or repair
improper maintenance,use not in accordance with product instructions, or connection to incorrect voltage
any use of accessories not supplied or approved by the manufacturer.

Information: The warranty will be invalidated if the nameplate and/or the serial number of the product are missing.

REPAIR SERVICES

In the event of a malfunction during the period of the manufacturer’s warranty: any request for support must be made to the professional retailer from whom you purchased your product. It is therefore guaranteed for 2 years from the date of purchase. Keep your receipt which will serve as proof of purchase.
In the event of a malfunction, you must return your product to your point of sale.

TECHNICAL SPECIFICATION

Item reference: OCEACV2000
Model: NDK20-21A
Voltage/Frequency: 220-240V~ 50Hz
Rated Power: 1700-2000W
Instruction manual version: V1

Model identifier(s): NDK20-21A (Ref: OCEACV2000)

output

| Pmax,c| 2,0| kW| | electronic heat charge control with room and/or outdoor temperature feedback| [no]
Auxiliary electricity consumption| | | | | fan assisted heat output| [no]
At nominal heat output| el max| N/A| kW| | Type of heat output/room temperature control (select one)
At minimum heat output| el min| N/A| kW| | single stage heat output and no room temperature control| [no]
---|---|---|---|---|---|---
In standby mode| el SB| 0,000| kW| | Two or more manual stages, no room temperature control| [no]
| | with mechanic thermostat room temperature control| [yes]
| | with electronic room temperature control| [no]
| | electronic room temperature control plus day timer| [no]
| | electronic room temperature control plus week timer| [no]
| | Other control options (multiple selections possible)
| |

room temperature control, with

presence detection

| [no]
| |

room temperature control, with open

window detection

120-126 quai de Bacalan CS 11584

33000 BORDEAUX

CORRECT DISPOSAL OF THIS PRODUCT

This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

OCEANIC
120-126 Quai de Bacalan CS 11584
33000 Bordeaux

IMPORT BY:
A.M.C.
123, QUAI JULES GUESDE 94400 VITRY SUR SEINE France