oceanic OCEAVT40CM2 40cm Table Fan Diameter User Manual

oceanic OCEAVT40CM2 40cm Table Fan Diameter

Important safety instructions

Please read this instruction manual fully before using this device and keep it safe for future reference.

• This appliance is for home use only.
• Any use other than that intended for this device, or for an application other than the one intended (e.g. commercial use), is prohibited.
• If the supply cord is damaged, it must be replaced by the manufacturer, a service agent, or a similarly qualified person in order to avoid potential hazards.
• The fan should only be used according to the rated voltage.
• When using the fan, do not handle or push objects into the grille.
• Before moving the fan, turn off the power supply first.
• This appliance can be used by children aged from 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, but only if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance should not be made by children without supervision
• Always place the device on a stable surface when using it.
• Do not let the power cord hang over the edge of a table or countertop.
• Make sure that the power cable never comes into contact with a hot surface.
• Before cleaning the fan, first disconnect from the mains, then disassemble the grille and blades. Use a soft damp cloth to wipe away grease and dust. Do not use gasoline or other corrosive liquids.Pay attention to not alter the angle of the blades.
• Water and other liquids should not be allowed to enter the motor.
• Do not cover the fan when in use.
• Unplug the fan before leaving home.
• Unplug the cord before moving.
• Do not unplug the fan by pulling on the power cable. Grasp the plug and pull it out to disconnect it.
• Do not allow hair, curtains, tablecloths and loose clothing to come into contact with the fan’s moving parts, as this may cause personal injury and property damage.
• Do not use this fan in places where flammable liquids are used or stored.
• The fan is not designed for outdoor use. The fan is for indoor use only. Do not use outdoors.
• Fan overheating protection: The fan motor is installed with a thermal fuse. When motor overheating occurs, the thermal fuse will cut off the power supply, and the motor temperature will stop rising and prevent the risk of melting or burning.
• Ensure that the fan is switched off from the electrical mains before removing the guard.
• Do not try to repair this fan yourself.
• Any repair operation must be carried out by the manufacturer, its after-sales service or aqualified repair agent so as to avoid any danger

Appliance specifications

TECHNICAL CHARACTERISTICS

Rated voltage| 220-240 V
Rated frequency| 50 Hz
Rated wattage| 45 W
Ambient operating temperature| 20±5 °C
Electrical protection class| II
Maximum fan flow rate| 67.18 m³/min
Fan sound power level| 51.51 dB(A)
Service value| 1.73 (m³/min)/W
Maximum air speed| 2.75 meters / sec
Seasonal electric consumption| 12.42 kWh/a
Service value measurement standard| CEI 60879: 1986

EN 60704-2-7 :1998

EN 60704-1 :2010 + A11: 2012

EN 50564 :2011

Contact details for more information| Oceanic

120-126 Quai de Bacalan CS 11584 33000 Bordeaux

Assembly

1. Front grille
2. Nut
3. Blade
4. Plastic Screw
5. Rear Grille
6. Body
7. Screw TM2.5*10
8. Base
9. Insert the motor unit into the base.
10. Place the rear protection grid on the motor unit axis.
11. Insert the blades between their rear nut and their front nut. Tighten the nuts by hand.
12. Place the front protection grille and tighten the screw.

USE

To start and select the fan speed, use the following buttons:

1. STOP
2. LOW SPEED
3. MIDDLE SPEED
4. HIGH SPEED

Operate this knob to control oscillation to allow air to cover a larger area, or to choose a directional flowat arequired angle.

CARE AND CLEANING

Always turn off the fan and unplug it from the power outlet before cleaning. Clean the fan with a slightly damp cloth, then dry it. Do not immerse the motor housing in water or any other liquid. Do not use chemical or abrasive cleaners.

Storage
When you are not using the fan, store it in a dry and secure place.

• If stored disassembled, it is recommended that you use the original box (or an appropriately sizedbox).
• If stored assembled or partially assembled, protect the fan head from dust.

DISPOSAL OF WASTE

As responsible distributors, we attach great importance to the protection of the environment. We encourage you to follow the correct disposal procedures for your device, batteries and packaging. This will help to conserve natural resources and ensure that the product and parts are recycled in a way that is respectful of health and the environment. You must dispose of this product and its packaging according to local laws and regulations. Since this product contains electronic components and sometimes batteries, the product and its accessories should be disposed of separately from household waste when the product reaches the endof its life. For more information on disposal and recycling procedures, contact the authorities in your local area. Take the device to a local collection point for recycling. Some centers accept products for free.

Oceanic:

• 120-126 Quai de Bacalan CS 11584 33000 Bordeaux

Imported by:

• A.M.C.
• 123, QUAI JULES GUESDE 94400 VITRY SUR SEINE
• France

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>