Eltako F4T55E Wireless Sensor without Battery or Wire Instruction Manual
- October 27, 2023
- Eltako
Table of Contents
Eltako F4T55E Wireless Sensor without Battery or Wire
Temperature at mounting location: -20°C up to +50°C.
Storage temperature: -25°C up to +70°C.
Relative humidity: annual average value <75%.
Wireless pushbutton for single mounting 80x80x15mm or mounting into the 55mm switching system. Generates the power for wireless telegrams itself when the button is pressed, therefore there is no connecting wire and no standby loss.
The scope of supply comprises the frame R1UE55, a flat double rocker (all same
colour), an attachment frame, a mounting base, the wireless module and one
adhesive foil.
Wireless pushbuttons with double rockers can transmit four evaluable signals:
press two rockers up or down.
The mounting base can be screwed onto a flat surface or glued to the wall, on
glass or on furniture using the enclosed adhesive foil.
Use the sleeves in the 55mm socket box for screw mounting.
Adhesion: First adhere the set comprising the mounting base, frame and
attachment frame – with the latches pointing at the top and bottom. Then snap
on the set comprising the wireless module and double rocker.
Before screwing, remove the mounting base from the frame and the attachment
frame.
To do this, press the latches on the mounting base outwards. Then screw the
mounting base – with the latches at top and bottom –, snap on the frame with
the attachment frame and snap on the set comprising the wireless module and
double rocker.
We recommend stainless-steel countersunk screws 2.9x25mm, DIN 7982 C, for
screw connections. Both with rawl plugs 5x25mm and with 55mm switch boxes.
The wireless module integrated in the wireless pushbutton can be taught-in
encrypted as described in the operating instructions in all encryptable
actuators of the Series 61, 62 and 71 as well as the FAM14.
This requires the FTVW wireless pushbutton encryption rocker. Encryptable
actuators bear the pictogram .
Teaching-in wireless sensors in wireless actuators
All sensors must be taught-in in the actuators so that they can detect and
execute commands.
The teach-in process is described in the operation manual of the actuators.
Manuals and Documents in further Languages
http://eltako.com/redirect/F4T55E-
Frequency: 868.3 MHz
Transmit power max.: 10 mW
Hereby, Eltako GmbH declares that the radio equipment type F4T55E- is in com
pliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address: eltako.com
Must be kept for later use!
Eltako GmbH
D-70736 Fellbach
Technical Support English:
+49 711 94350025
technical-support@eltako.de
eltako.com
35/2022 Subject to change without notice.