Eltako FBA14 Bus Coupler Instructions
- May 15, 2024
- Eltako
Table of Contents
FBA14 Bus Coupler
Instructions
FBA14 Bus Coupler
FBA 14
Bus coupler for wire connections of bus and power supply jumpers Series 14.
Modular device for DIN-EN 60715 TH35 rail mounting.
1 module = 18 mm wide, 58 mm deep.
Bus cross wiring and power supply with jumper.
Bus coupler FBA14 can connect various bus parts as well as feed power
supplies.
Bus parts on different DIN rails or in other distributors or switch cabinets
are each connected to an FBA 14 and a 4-wire screened bus line, e.g. a
telephone line. The total length of all connecting lines should not exceed 100
m. A 9 mm wide second terminating resistor (supplied with the FAM14
respectively FTS14KS) must be plugged into the last actuator.
The bus coupler may be positioned at any point in a Series 14 device row. The
4 wires of the bus line are connected to the -12 V, +12 V, RSA and RSB
terminals of the two FBA14s.
The jumper plugged in ex works to the lower terminal block must remain fitted
to .
This jumper also remains fitted if a switch mode power supply unit
FSNT12-12V/12W is connected to the +12 V and -12 V terminals to produce power
supply redundancy.
If the power supply of the switch mode power supply unit in the FAM14 or
FTS14KS is insufficient to power the entire RS485 bus, a switch mode power
supply unit SNT12-230V/12V DC-1A can be connected to the -12 V and +12V
terminals of the bus coupler to increase capacity. In this case the jumper
must be removed.
Actuators to the left of the bus coupler are powered by the FAM14 or FTS14KS,
actuators to the right are powered by the switch mode power supply unit.
| FBA14 | RS485 bus coupler | Art. No. 30014018 | 32,40 €/pc. |
|---|
Manuals and documents in further languages: http://eltako.com/redirect/FBA14
Housing for operating instructions GBA14
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>