NIGHTSTICK XPR-5562GX Dicata Intrinsically Safe Low Profile dual Light Instruction Manual

NIGHTSTICK XPR-5562GX Dicata Intrinsically Safe Low Profile dual Light

THE XPR-5562 IS APPROVED FOR USE

INTRINSICALLY SAFE

WARNINGS

• To prevent ignition of a hazardous atmosphere, the XPR-5562 must only be charged in an area known to be non-hazardous.

• Use only the approved Nightstick 5562-BATT Lithium-ion rechargeable battery pack.

• The approved Nightstick 5562-BATT Lithium-ion rechargeable battery pack must be replaced by a qualifi ed technician only.

• To prevent ignition of a hazardous atmosphere, do not open the battery compartment or attempt to exchange the battery pack while in the hazardous environment.
  This task must ONLY be performed in an area known to be non-hazardous.

• Open the battery compartment on the XPR-5562 and replace the approved Nightstick 5562-BATT Lithium-ion rechargeable battery pack in fresh air only.

• Substitution of components may impair intrinsic safety.

SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
For personal safety, always confi rm the rating of any known hazardous or potentially hazardous location where the light is to be used.

CHARGING THE LIGHT

WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT TO CHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BE PERFORMED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
Use only the supplied Nightstick rechargeable battery and Magmate™ cable. Fully charge the light before the fi rst use, or if the battery is new or has been unused for several months. For best performance, charge the light when the fl ashlight beam starts to dim.

• Connect the Magmate cable to a power source with a USB connector. Attach the magnetic end to the charging port located on the light.
• The USB end of the cable includes an LED charge status indicator. The LED indicator remains red until the battery is fully charged. At full charge, the LED indicator turns green.
• The total time to fully charge the light varies depending on the remaining charge in the battery.

OPERATION

Two switches on the front of the headlamp control all functions.
SPOTLIGHT SWITCH

• First Press = spotlight high-brightness
• Second Press = spotlight low-brightness
• Third Press = off

FLOODLIGHT SWITCH

• First Press = fl oodlight high-brightness
• Second Press = fl oodlight low-brightness
• Third Press = off

DUAL-LIGHT MODE

• Press each switch one time to turn on both lights in high-brightness mode.
• To shut down Dual-Light mode, press each switch two more times until each light turns off.

WARRANTY

LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and materials for the original purchaser’s lifetime. The Limited Lifetime Warranty includes the LEDs, housing and lenses. Rechargeable batteries, chargers, switches, electronics and included accessories are warranted for a period of two years with proof of purchase. Normal wear and failures which are caused by accidents, misuse, abuse, faulty installation and lightning damage are excluded.
We will repair or replace this product should we determine it to be defective. This is the only warranty, expressed or implied, including any warranty of merchantability or fitness for a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco- productsupport/warranties. Retain your receipt for proof of purchase.

Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • USA • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-XPR-5562-DL-20

EU Declaration of Conformity (DoC) XPR-5562GX

Company name          Bayco Products
Postal address:            640 Sanden Blvd.
Postcode and City:     75098
Declare that the DoC is issued under our sole responsibility and belongs to the following product:

Apparatus model/Product:    XPR-5562GX
Type:                                     Headlamp
ATEX Directive 2014/34/EU

UL International Demko A/S, notified body number 0539 in accordance with Article 17 of the Council Directive 2014/34/EU of 26 February 2014, certifies that this product has been found to comply with the Essential Health and Safety Requirements relating to design and construction of products intended for use in potentially explosive atmospheres given in Annex II to the Directive. The examination and test results are recorded in confidential report no. 4789034348.2.1

The following harmonised standards and technical specifications have been applied:
Evaluated to the following safety standards by Underwriters Laboratories (U.L.):
EN 60079-0:2012/A11:2013 EN 60079-11:2012 (ia) EN 60079-28: 2015

These Products are fully compliant and do not contain the restricted substances above levels noted in EU RoHS 2011/65/EU (RoHS 2) / 2015/863 (RoHS 2 amendment) / EU REACH regulation (EC) No 1907/2006.

Certificate No. DEMKO 20 ATEX 2267 Rev. 0

Name: James Conner Engineer
Date of issue: 05/27/2020
Form F-900-001 Rev-A

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>