NIGHTSTICK 5522-BATT High Capacity Battery Instructions
- June 4, 2024
- NIGHTSTICK
Table of Contents
NIGHTSTICK 5522-BATT High Capacity Battery
WARNINGS
- WARNING: It is recommended that a qualified technician perform the replacement of the rechargeable battery pack in this light.
- WARNING: Failure to follow these instructions may impair the intrinsic safety of this flashlight.
- WARNING: To prevent the ignition of a hazardous atmosphere, do not open the lens bezel in the hazardous environment. This task must only be performed in an area known to be non-hazardous.
- WARNING: When exchanging the rechargeable battery pack, use only the approved 5522-BATT rechargeable battery pack from basic products.
- WARNING: To prevent the ignition of a hazardous atmosphere, the rechargeable battery pack must only be exchanged in an area known to be non-hazardous.
REPLACING THE LITHIUM-ION RECHARGEABLE BATTERY
-
Loosen the locking screw on the side of the bezel. CAUTION: Do NOT remove the locking screw.
-
Unscrew the lens bezel from the housing in a counter-clockwise direction.
-
Loosen each of the two charger contact pins located below the Floodlight Lens. These two screws should be loosened until approximately 1/8” of thread is visible.
CAUTION: Do NOT remove these two screws. -
Turn the light upside down and remove the reflector/circuit assembly. CAUTION: Do NOT touch the reflector surface with your finger. Doing so may damage the reflector surface.
-
Remove the old 5522-BATT rechargeable battery pack paying attention to the battery pack’s orientation within the handle. Please recycle the used battery.
-
Using only the approved replacement 5522-BATT rechargeable battery pack from Bayco Products, slide the new battery pack into the handle of the light using the directional arrow marked on the side of the pack as a guide for proper orientation.
-
Align the reflector/circuit assembly so that the switches on the assembly are aligned with the switches on the housing. Fully insert the assembly back into the flashlight housing.
-
Tighten both of the charger contact screws fully.
-
Replace the lens bezel onto the housing in a clockwise direction until tight.
-
Tighten the locking screw located on the side of the lens bezel. CAUTION: Do NOT over-tighten. Doing so may damage the threads.
WARRANTY
2-Year Limited Warranty. Go to www. nightstick.com for warranty information.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098
1-800-233-2155 •
1-469-326-9400 •
www.nightstick.com
INS-5522-BATT-21
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>