NIGHTSTICK XPR-5553G Intrinsically Safe Dual-Light Rechargeable Headlamp Instruction Manual
- June 4, 2024
- NIGHTSTICK
Table of Contents
NIGHTSTICK XPR-5553G Intrinsically Safe Dual-Light Rechargeable Headlamp
WARNINGS – INTRINSICALLY SAFE
- Warning: To prevent the ignition of a hazardous atmosphere, the XPR-5553 must only be charged in an area known to be non-hazardous.
- Warning: Use only the approved Nightstick 5562-BATT Lithium-ion rechargeable battery pack.
- Warning: The approved Nightstick 5562-BATT Lithium-ion rechargeable battery pack must be replaced by a qualified technician only.
- Warning: To prevent ignition of a hazardous atmosphere, do not open the battery compartment or attempt to exchange the battery pack while in the hazardous environment. This task must ONLY be performed in an area known to be non-hazardous.
- Warning: Open the battery compartment on the XPR-5553 and replace the approved Nightstick 5562-BATT Lithium-ion rechargeable battery pack in fresh air only.
- Warning: Substitution of components may impair intrinsic safety
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
For personal safety, always confirm the rating of any known hazardous or potentially hazardous location where the light is to be used.
CHARGING THE LIGHT
- CHARGER INPUT: 5 VDC Max
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT TO CHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BE PERFORMED IN AN AREA KNOWN TO BE NON-HAZARDOUS. Fully charge the light before the first use, or if the battery is new or has been unused for several months. For best performance, charge the light when the headlamp beam starts to dim.
- Use only the supplied Nightstick USB cable.
- Locate the USB port on the back of the headlamp, remove the rubber USB port cover, and plug the micro USB into the headlamp’s micro USB port.
- The total time to full charge varies depending on the remaining charge in the battery pack.
- The charge indicator light located above the charging port will turn red while charging and green when fully charged.
OPERATION
LIGHTING MODES
- SPOTLIGHT: Press the switch one time to turn on the spotlight.
- FLOODLIGHT: Press the switch two times to turn on the floodlight.
- DUAL-LIGHT: Press the switch three times to turn on both the spotlight and the floodlight at the same time for Dual-Light mode.
- OFF: Press the switch a fourth time to turn it off.
TILT ADJUSTMENT FEATURE:
Adjust the tilt angle of the light to illuminate the desired area.
HEADBANDS AND HELMET MOUNT
- Use the elastic non-slip headband for wearing directly on your head or on a soft hat such as a ball cap.
- Use the heavy-duty rubber headband on any hard hat.
ZERO BAND MOUNTING INSTRUCTIONS
Use the 3M™ Dual-Lock™ Reclosable Fastener (included) to mount the light onto
a hard hat or helmet. Adhere one side to the backplate on the light and the
other side onto a clean, smooth surface on the front of the helmet.
- Remove headband
- Ensure the mounting surface is clean and oil-free (use an alcohol wipe if needed)
- Prior to installing, determine the mounting location that allows the headlamp to fully tilt without interfering with the helmet brim.
- Remove adhesive backing from each side of the fastener and adhere to the helmet and the back of the bracket.
- Firmly press light into place on the helmet.
- Note: adhesive reaches peak strength in 24 hours.
WARRANTY
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in
workmanship and materials for the original purchaser’s lifetime. The Limited
Lifetime Warranty includes LEDs, housing, and lenses. Rechargeable batteries,
chargers, switches, electronics and included accessories are warranted for a
period of two years with proof of purchase. Normal wear and failures which are
caused by accidents, misuse, abuse, faulty installation and lightning damage
are excluded. We will repair or replace this product should we determine it to
be defective. This is the only warranty, expressed or implied, including any
warranty of merchantability or fitness for a particular purpose. For a
complete copy of the warranty, go to www.baycoproducts.com/bayco-
productsupport/warranties. Retain your receipt for proof of purchase.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>