NIGHTSTICK NSR-2492 Multi-Purpose Rechargeable Dual-Light Work Light Instruction Manual

: October 30, 2023
: NIGHTSTICK

Table of Contents

NIGHTSTICK NSR-2492 Multi-Purpose Rechargeable Dual-Light Work Light
CHARGING
OPERATION
WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

NIGHTSTICK NSR-2492 Multi-Purpose Rechargeable Dual-Light Work Light

NIGHTSTICK-NSR-2492 Multi-Purpose-Rechargeable-Dual-Light-Work-Light-
product

Please read these instructions before using your work light. Be sure to charge the work light before the fi rst use.

CAUTION : Do not use this work light in explosive atmospheres, near fl ammable liquids, or where explosion-proof lamps are required. Do not immerse in water.
CAUTION : For light duty work only.

CHARGING

Initial Use
Fully charge the work light before the ﬁ rst use. If the battery is new or has been unused for several months, several charge and discharge cycles may be needed to reach full battery capacity. To reach maximum performance, run the light to completely discharge the battery and then recharge. Each charge cycle will extend the operation time until maximum capacity is achieved. The charge time for maximum capacity is approximately 4 hours.

CHARGER INPUT : 12 VDC Max

Regular Use

Use only the supplied AC or DC charging adapter.
For best performance, charge the work light when the LED’s start to dim.
Connect the AC power adapter to the light. The red indicator will light.
The red light indicates the work light is being charged. The red light remains on until the battery is fully charged. At full charge, the light turns off. The total time to full charge varies depending on the remaining charge in the battery pack.
Keep the work light plugged into the charger to maintain a trickle charge.

TIPS TO EXTEND BATTERY LIFE

The work light NiMH internal battery pack does not have a memory effect. Charging the work light often helps extend its useful life.
A new work light or one that has not been used for a long period of time may not accept a full charge initially. This is normal and does not indicate a problem. Fully discharge and then charge the unit several times to condition the battery pack for full capacity. As the battery pack capacity increases the charge time shortens.
Charge the unit after each use, whether the work light is fully discharged or not.
Store the work light at room temperature

OPERATION

The work light has two buttons located on the back of the handle. The top button turns the Spotlight on or off. The bottom button turns the Floodlight on or off. Pressing both buttons will put the user into Dual-Light Mode.

WARRANTY

1 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and materials to the original purchaser for 1 year from the date of purchase, and includes the LEDs, housing, lenses, electronics, switches, rechargeable batteries and chargers. Bulbs (other than LEDs) are covered for 90 days from the date of purchase. We will repair or replace this product should we determine it to be defective. This is the only warranty, expressed or implied, including any warranty of merchantability or ﬁ tness for a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco- product-support/warranties. Retain your receipt for proof of purchase.

Bayco Products, Inc. 640 South Sanden Blvd. Wylie, TX 75098